USB3370 Datasheet | Microchip Technology

Enhanced Single Supply Hi-Speed USB ULPI Transceiver Highlights - USB-IF Battery Charging 1.1 Specification pliant - Link Power Management (LPM) Specification pliant - Integrated ESD protection circuits - Up to ±25k V IEC Air Discharge without external devices - Over-Voltage Protection circuit (OVP) protects the VBUS pin from continuous DC voltages up to 30V - Microchip Rapid Charge Anywhere™ Provides: - 3-times the charging current through a USB port over traditional solutions - USB-IF Battery Charging 1.1 pliance to any portable device - Charging current up to 1.5Amps via patible USB host or dedicated charger - Dedicated Charging Port (DCP), Charging (CDP) & Standard (SDP) Downstream Port support - flex PWR® Technology - Extremely low current design ideal for battery powered applications - “Sleep” mode tri-states all ULPI pins and places the part in a low current state - 1.8V to 3.3V IO Voltage - Single Power Supply Operation - Integrated 1.8V regulator - Integrated 3.3V regulator - 100m V dropout voltage - PHYBoost - Programmable USB transceiver drive strength for recovering signal integrity - Vari Sense TM - Programmable USB receiver sensitivity - “Wrapper-less” design for optimal timing performance and design ease - Low Latency Hi-Speed Receiver (43 Hi Speed clocks Max) allows use of legacy UTMI Links with a ULPI bridge - External Reference Clock operation available - 19.2MHz Reference Clock needed - ULPI Clock Input Mode (60MHz sourced by Link) - 0 to 3.6V input drive tolerant - Able to accept “noisy” clock sources as reference to internal, low-jitter PLL - Crystal support available - Smart detection circuits allow identification of USB charger, headset, or data cable insertion - Includes full support for the optional On-The-Go (OTG) protocol detailed in the On-The-Go Supplement Revision 2.0 specification - Supports the OTG Host Negotiation Protocol (HNP) and Session Request Protocol (SRP) - UART mode for non-USB serial data transfers - Internal 5V cable...