PD69100
PD69100 is PoE Controller Unit manufactured by Microsemi.
.Microsemi .
® TM
DESCRIPTION
Microsemi’s™ Po E controller, PD69100, is a costeffective, pre-programmed unit designed to implement Enhanced mode. It is used in conjunction with Microsemi’s Po E Managers PD69108 and PD69104 in Ethernet switches to enable next generation network devices to share power and data over the same cable, as specified in IEEE802.3af and IEEE802.3at standards. Enhanced mode operation along with PD69108/PD69104 managers enables operation in a total Power-over-Ethernet standalone mode.
The controller Features an ESPI bus for each Po E device and a munication interface with Host CPU via UART or I2C protocol.
Device is based on STMicroelectronics family STM32F101T6 embedded with ARM Cortex™-M3 core. It includes the following peripherals:
- 3 x Timers
- 2 x Uarts
- 1 x SPI
- 1 x I2C
- 1 x 12-bit analog-to-digital converter
PIN CONFIGURATION
VDD2 VSS2 SWDIO x LED_OE x LED_Latch I2C_Message_Ready x Int_Out x LED_CS VDD1
27 26 25 24 23 22 21 20 19
SWCLK 28 x Disable_Ports 29 x Hswp_On 30 Spare 31 x Sys_OK 32 SCL / UART1_TX 33 SDA / UART1_RX 34
Boot0 35 VSS3 36
<Part Number > < -Software Ver > < Date Code >
12 3 4 5 6 7 8 9
18 VSS1 17 Reserved 16 I2C_ADDR 15 HW_VER 14 ESPI_MOSI 13 ESPI_MISO 12 ESPI_SCK 11 ESPI_x CS 10 Reserved
Po E Controller Unit
KEY Features
- Controls up to 48 Po E ports (6 x PD69108)
- Pre-Standard / Capacitor detection
- Detection of Cisco devices
- Supports both UART and I2C interfaces to
Host CPU
- Backwards patible with PD69000,
PD63000, PD62000 and PDIC66000
- Supports 2 pair RJ or 4 pair RJ
- 16 power banks support using four discrete lines connected directly to PD69108 /...
