SG2543 Datasheet | Microsemi

SG1543/SG2543/SG3543 Power Supply Output Supervisory Circuit Description This monolithic integrated circuit contains all the functions necessary to monitor and control the output of a sophisticated power supply system. Over-voltage (O.V.) sensing with provision to trigger an external SCR “crowbar” shutdown; an under-voltage (U.V.) circuit which can be used to monitor either the output or to sample the input line voltage; and a third op amp/parator usable for current sensing (C.L.) are all included in this IC, together with an independent, accurate reference generator. Both over and under-voltage sensing circuits can be externally programmed for minimum time duration of fault before triggering. All functions contain open collector outputs which can be used independently or wire-ORed together; and although the SCR trigger is directly connected only to the over-voltage sensing circuit, it may be optionally activated by any of the other outputs, or from an external signal. The O.V. circuit also includes an optional latch and external reset capability. The current sense circuit may be used with external pensation as a linear amplifier or as a high gain parator. Although nominally set for zero input offset, a fixed threshold may be added with an external resistor. Instead of current limiting, this circuit may also be used as an additional voltage monitor. The reference generator circuit is internally trimmed to eliminate the need for external potentiometers and the entire circuit may be powered directly from either the output being monitored or from a separate bias voltage. Block Diagram Features - Over-Voltage, Under-Voltage, and Current Sensing Circuits all included. - Reference Voltage Trimmed to 1% Accuracy. - SCR "Crowbar" Drive of 300m A. - Programmable Time Delays. - Open-Collector Outputs and Remote Activation Capability. - Total Standby Current less than 10m A. High Reliability Features - Available to MIL-STD-883, ¶ 1.2.1 - MSC-AMS level “S”...