Datasheet4U Logo Datasheet4U.com

MC145193 - 1.1 GHZ PLL FREQUENCY SYNTHESIZER

General Description

section.

2.

ESD (electrostatic discharge) immunity meets Human Body Model (HBM) ≤2000 V and Machine Model (MM) ≤200 V.

Key Features

  • a single.
  • ended current source/sink phase detector A output and a double.
  • ended phase detector B output. Both phase detectors have linear transfer functions (no dead zones). The maximum current of the single.
  • ended phase detector output is determined by an external resistor tied from the Rx pin to ground. This current can be varied via the serial port. Slew.
  • rate control is provided by a special driver designed for the REFout pin. This minimizes interference caused by.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
MC145191 1.1 GHz PLL Frequency Synthesizers NXP
MC14511 BCD-TO-SEVEN SEGMENT LATCH/DECODER/DRIVER UTC
MC14511B BCD-To-Seven Segment Latch/Decoder/Driver ON Semiconductor
MC14512B 8-Channel Data Selector ON Semiconductor
MC14513B BCD-To-Seven Segment Latch/Decoder/Driver ON Semiconductor

Other Datasheets by Motorola Semiconductor (now NXP Semiconductors)

Part Number Description
MC145190 1.1 GHz PLL Frequency Synthesizers
MC145191 1.1 GHz PLL Frequency Synthesizers
MC145192 Low-Voltage 1.1 GHz PLL Frequency Synthesizer
MC14519B 4-Bit AND/OR Selector or Quad 2-Channel Data Selector or Quad Exclusive NOR Gate
MC145100 4 X 4 CROSSPOINT SWITCH

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
Order this document by MC145193/D MC145193 1.1 GHz PLL Frequency Synthesizer The MC145193 is recommended for new designs and offers reduced power consumption. The counters are programmed via a synchronous serial port which is SPI compatible. The serial port is byte-oriented to facilitate control via an MCU. Due to the innovative BitGrabber Plus™ registers, the MC145193 may be cascaded with other peripherals featuring BitGrabber Plus without requiring leading dummy bits or address bits in the serial data stream. In addition, BitGrabber Plus peripherals may be cascaded with existing BitGrabber™ peripherals. The device features a single–ended current source/sink phase detector A output and a double–ended phase detector B output.