LPC1519JBD100 Datasheet | NXP Semiconductors

LPC15xx 32-bit ARM Cortex-M3 microcontroller; up to 256 k B flash and 36 k B SRAM; FS USB, CAN, RTC, SPI, USART, I2C Rev. 1 - 19 February 2014 Product data sheet 1. General description The LPC15xx are ARM Cortex-M3 based microcontrollers for embedded applications featuring a rich peripheral set with very low power consumption. The ARM Cortex-M3 is a next generation core that offers system enhancements such as enhanced debug Features and a higher level of support block integration. The LPC15xx operate at CPU frequencies of up to 72 MHz. The ARM Cortex-M3 CPU incorporates a 3-stage pipeline and uses a Harvard architecture with separate local instruction and data buses as well as a third bus for peripherals. The ARM Cortex-M3 CPU also includes an internal prefetch unit that supports speculative branching. The LPC15xx includes up to 256 k B of flash memory, 32 k B of ROM, a 4 k B EEPROM, and up to 36 k B of SRAM. The peripheral pliment includes one full-speed USB 2.0 device, two SPI interfaces, three USARTs, one Fast-mode Plus I2C-bus interface, one C_CAN module, PWM/timer subsystem with four configurable, multi-purpose State Configurable Timers (SCTimer/PWM) with input pre-processing unit, a Real-time clock module with independent power supply and a dedicated oscillator, two 12-channel/12-bit, 2 Msamples/s ADCs, one 12-bit, 500 k Samples/s DAC, four voltage parators with internal voltage reference, and a temperature sensor. A DMA engine can service most peripherals. For additional documentation related to the LPC15xx parts, see Section 17 “References”. 2. Features and benefits - System: - ARM Cortex-M3 processor (version r2p1), running at frequencies of up to 72 MHz. - ARM Cortex-M3 built-in Nested Vectored Interrupt Controller (NVIC). - System tick timer. - Serial Wire Debug (SWD) with four breakpoints and two watchpoints. - Single-cycle multiplier supported. - Memory Protection Unit (MPU) included. - Memory: - Up to 256 k B on-chip flash programming memory with 256...