Datasheet4U Logo Datasheet4U.com

PCA9530 - 2-bit I2C-bus LED dimmer

General Description

The PCA9530 is a 2-bit I2C-bus and SMBus I/O expander optimized for dimming LEDs in 256 discrete steps for Red/Green/Blue (RGB) color mixing and backlight applications.

The PCA9530 contains an internal oscillator with two user programmable blink rates and duty cycles coupled to the output PWM.

Key Features

  • I 2 LED drivers (on, off, flashing at a programmable rate) I 2 selectable, fully programmable blink rates (frequency and duty cycle) between 0.591 Hz and 152 Hz (1.69 seconds and 6.58 milliseconds) I 256 brightness steps I Input/output not used as LED drivers can be used as regular GPIOs I Internal oscillator requires no external components I I2C-bus interface logic compatible with SMBus I Internal power-on reset www. DataSheet4U. com NXP Semiconductors PCA9530 2-bit I2C-bus LED dimmer I I I I.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
PCA9531 8-bit I2C LED dimmer NXP
PCA9532 16-bit I2C LED dimmer NXP
PCA9533 4-bit I2C LED dimmer NXP
PCA9534 8-bit I2C and SMBus/ low power I/O port NXP
PCA9534 Remote 8-Bit I2C and SMBus Low-Power I/O Expander Texas Instruments

Other Datasheets by NXP Semiconductors

Part Number Description
PCA9502 8-bit I/O expander
PCA9506 40-bit I2C-bus I/O port
PCA9507 2-wire serial bus extender
PCA9510A Hot swappable I2C-bus and SMBus bus buffer
PCA9511A Hot swappable I2C-bus and SMBus bus buffer

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
www.DataSheet4U.com PCA9530 2-bit I2C-bus LED dimmer Rev. 03 — 26 February 2009 Product data sheet 1. General description The PCA9530 is a 2-bit I2C-bus and SMBus I/O expander optimized for dimming LEDs in 256 discrete steps for Red/Green/Blue (RGB) color mixing and backlight applications. The PCA9530 contains an internal oscillator with two user programmable blink rates and duty cycles coupled to the output PWM. The LED brightness is controlled by setting the blink rate high enough (> 100 Hz) that the blinking cannot be seen and then using the duty cycle to vary the amount of time the LED is on and thus the average current through the LED. The initial setup sequence programs the two blink rates/duty cycles for each individual PWM.