Datasheet4U Logo Datasheet4U.com

MC33HB2000 - SPI programmable brushed DC motor driver

General Description

The MC33HB2000 is a SMARTMOS monolithic H-Bridge Power IC, enhanced with SPI configurability and diagnostic capabilities.

It is designed primarily for DC motor or servo motor control applications within the specified current and voltage limits.

Key Features

  • Advanced diagnostic reporting via a serial peripheral interface (SPI): charge pump undervoltage, overvoltage, and undervoltage on VPWR, short to ground and short to VPWR for each output, open load, temperature warning and overtemperature shutdown.
  • Thermal management: Excellent thermal resistance of.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
MC33001 GENERAL PURPOSE SINGLE JEFT OPERATIONAL AMPLIFIERS ST Microelectronics
MC33001A GENERAL PURPOSE SINGLE JEFT OPERATIONAL AMPLIFIERS ST Microelectronics
MC33001B GENERAL PURPOSE SINGLE JEFT OPERATIONAL AMPLIFIERS ST Microelectronics
MC33004 GENERAL PURPOSE QUAD J-FET OPERATIONAL AMPLIFIERS STMicroelectronics
MC33004A GENERAL PURPOSE QUAD J-FET OPERATIONAL AMPLIFIERS STMicroelectronics

Other Datasheets by NXP Semiconductors

Part Number Description
MC33HB2001 SPI programmable brushed DC motor driver
MC3302 Quad voltage comparator
MC33198 HIGH-SIDE TMOS DRIVER
MC33493 PLL Tuned UHF Transmitter
MC3361 Low Power Narrowband FM IF

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
MC33HB2000 10 A H-bridge, SPI programmable brushed DC motor driver Rev. 8 — 24 February 2020 Product data sheet 1 General description The MC33HB2000 is a SMARTMOS monolithic H-Bridge Power IC, enhanced with SPI configurability and diagnostic capabilities. It is designed primarily for DC motor or servo motor control applications within the specified current and voltage limits. The MC33HB2000 is able to control inductive loads with peak currents greater than 10 A. The nominal continuous average load current is 3.0 A. A current mirror output provides an analog feedback signal proportional to the load current. This part is designed to specifically address the ISO 26262 safety requirements.