Datasheet4U Logo Datasheet4U.com

NX5P3363-Q100 - USB PD and Type-C current-limited power switch

General Description

The NX5P3363/Q100 is a precision adjustable current-limited power switch for USB PD application.

The device includes undervoltage lockout, overtemperature protection, and reverse current protection circuits to automatically isolate the switch terminals when a fault condition occurs.

Key Features

  • VIN supply voltage range from 4.0 V to 5.5 V.
  • All time reverse current protection with ultra fast RCP recovery.
  • Adjustable current limit from 400 mA to 3.3 A.
  • Clamped current output in overcurrent condition.
  • 29 V high voltage tolerance on VBUS pin.
  • Low ON resistance of the power FETs: 35 mΩ (typical) in total.
  • Surge protection: IEC61000-4-5 exceeds ±80 V on VBUS.
  • Over temperature protection.
  • Qualified in accordance.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
NX5008NBKM N-channel Trench MOSFET nexperia
NX5020UNBK 50V N-channel Trench MOSFET nexperia
NX5020UNBKW 50V N-channel Trench MOSFET nexperia
NX5032SA Crystal Units ETC
NX5032SD Crystal Units ETC

Other Datasheets by NXP Semiconductors

Part Number Description
NX5P3363 power switch
NX5P3001 Bidirectional high-side power switch
NX5P3090 power switch
NX5P3290 Power Switch
NX5P1000 Logic controlled high-side power switch

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
NX5P3363/Q100 USB PD and Type-C current-limited power switch Rev. 1.1 — 10 September 2024 Product data sheet 1 General description The NX5P3363/Q100 is a precision adjustable current-limited power switch for USB PD application. The device includes undervoltage lockout, overtemperature protection, and reverse current protection circuits to automatically isolate the switch terminals when a fault condition occurs. The 29 V tolerance on VBUS pin ensures the device is able to work on a USB PD port; a current limit input (ILIM) pin defines the overcurrent limit threshold; an open-drain fault output (FLT) indicates when a fault condition has occurred. The overcurrent limit threshold can be programmed from 400 mA to 3.3 A, using an external resistor between the ILIM pin and GND pin.