PCA9545A Datasheet | NXP Semiconductors

4-channel I2C-bus switch with interrupt logic and reset Rev. 10 - 27 September 2022 Product data sheet 1 General description The PCA9545A is a quad bidirectional translating switch controlled via the I2C-bus. The SCL/SDA upstream pair fans out to four downstream pairs, or channels. Any individual SCx/SDx channel or bination of channels can be selected, determined by the contents of the programmable control register. Four interrupt inputs, INT0 to INT3, one for each of the downstream pairs, are provided. One interrupt output, INT, acts as an AND of the four interrupt inputs. An active LOW reset input allows the PCA9545A to recover from a situation where one of the downstream I2C-buses is stuck in a LOW state. Pulling the RESET pin LOW resets the I2C-bus state machine and causes all the channels to be deselected as does the internal power-on reset function. The pass gates of the switches are constructed such that the VDD pin can be used to limit the maximum high voltage which is passed by the PCA9545A. This allows the use of different bus voltages on each pair, so that 1.8 V or 2.5 V or 3.3 V parts can municate with 5 V parts without any additional protection. External pull-up resistors pull the bus up to the desired voltage level for each channel. All I/O pins are 5 V tolerant. 2 Features and benefits - 1-of-4 bidirectional translating switches - I2C-bus interface logic; patible with SMBus standards - Four active LOW interrupt inputs - Active LOW interrupt output - Active LOW reset input - Two address pins allowing up to four devices on the I2C-bus - Channel selection via I2C-bus, in any bination - Power-up with all switch channels deselected - Low Ron switches - Allows voltage level translation between 1.8 V, 2.5 V, 3.3 V and 5 V buses - No glitch on power-up - Supports hot insertion - Low standby current - Operating power supply voltage range of 2.3 V to 5.5 V - 5 V tolerant Inputs - 0 Hz to 400 k Hz clock frequency - ESD protection...