PN7150 Datasheet | NXP Semiconductors

description Plug´n play and high-performance full NFC solution PN7150 is a full NFC controller solution with integrated firmware and NCI interface designed for contactless munication at 13.56 MHz. It is patible with NFC forum requirements. PN7150 is designed based on learnings from previous NXP NFC device generation. It is the ideal solution for rapidly integrating NFC technology in any application, especially those running O/S environment like Linux and Android, reducing Bill of Material (BOM) size and cost, thanks to: - Full NFC forum pliancy (see [1]) with small form factor antenna - Embedded NFC firmware providing all NFC protocols as pre-integrated feature - Direct connection to the main host or microcontroller, by I2C-bus physical and NCI protocol - Ultra-low power consumption in polling loop mode - Highly efficient integrated power management unit (PMU) allowing direct supply from a battery PN7150 embeds a new generation RF contactless front-end supporting various transmission modes according to NFCIP-1 and NFCIP-2, ISO/IEC 14443, ISO/IEC 15693, MIFARE Classic IC-based card and Feli Ca card specifications. It embeds an Arm Cortex-M0 microcontroller core loaded with the integrated firmware supporting the NCI 1.0 host munication. It also allows to provide a higher output power by supplying the transmitter output stage from 3.0 V to 4.75 V. The contactless front-end design brings a major performance step-up with on one hand a higher sensitivity and on the other hand the capability to work in active load modulation munication enabling the support of small antenna form factor. Figure 1 lists the supported transmission modes. For contactless card functionality, the PN7150 can act autonomously if previously configured by the host in such a manner. PN7150 integrated firmware provides an easy integration and validation cycle as all the NFC real-time constraints, protocols and device discovery (polling loop) are being taken care internally. In few NCI mands, host SW...