DP83816 Datasheet | National Semiconductor

Description - Support for IEEE 802.3x Full duplex flow control - Extremely flexible Rx packet filtration including: single DP83816 is a single-chip 10/100 Mb/s Ethernet Controller address perfect filter with MSb masking, broadcast, 512 for the PCI bus. It is targeted at low-cost, high volume PC entry multicast/unicast hash table, deep packet pattern motherboards, adapter cards, and embedded systems. matching for up to 4 unique patterns The DP83816 fully implements the V2.2 33 MHz PCI bus - Statistics gathered for support of RFC 1213 (MIB II), interface for host munications with power management RFC 1398 (Ether-like MIB), IEEE 802.3 LME, reducing support. Packet descriptors and data are transferred via CPU overhead for management bus-mastering, reducing the burden on the host CPU. The DP83816 can support full duplex 10/100 Mb/s transmission - Internal 2 KB Transmit and 2 KB Receive data FIFOs and reception, with minimum interframe gap. - Serial EEPROM port with auto-load of configuration data The DP83816 device is an integration of an enhanced from EEPROM at power-on version of the National Semiconductor PCI MAC/BIU - Flash/PROM interface for remote boot support (Media Access Controller/Bus Interface Unit) and a 3.3V - Fully integrated IEEE 802.3/802.3u 3.3V CMOS physical CMOS physical layer interface. layer Features - IEEE 802.3 10BASE-T transceiver with integrated filters - IEEE 802.3 pliant, PCI V2.2 MAC/BIU supports - IEEE 802.3u 100BASE-TX transceiver traditional data rates of 10 Mb/s Ethernet and 100 Mb/s - Fully integrated ANSI X3.263 pliant TP-PMD Fast Ethernet (via internal phy) physical sublayer with adaptive equalization and Baseline Wander pensation - Bus master - burst sizes of up to 128 dwords (512 bytes) - BIU pliant with PC 97 and PC 98 Hardware Design - IEEE 802.3u Auto-Negotiation - advertised features configurable via EEPROM Guides, PC 99 Hardware Design Guide draft, ACPI v1.0, PCI Power Management Specification v1.1, On Now - Full Duplex support...