LM1283 Datasheet | National Semiconductor

Description The LM1283 is a full feature video amplifier with OSD inputs, all within a 28-pin package. This part is intended for use in monitors with resolutions up to 1280 x 1024. The video section of the LM1283 features three matched video amplifiers with blanking. All of the video amplifier adjustments feature high input impedance 0V to 4V DC controls, providing easy interfacing to bus controlled alignment systems. The OSD section features three TTL inputs and a DC contrast control. The switching between the OSD and video section is controlled by a single TTL input. Although the OSD signals are TTL inputs, these signals are internally processed to match the OSD logic low level to the video black level. When adjusting the drive controls for color balance of the video signal, the color balance of the OSD display will track these color adjustments. The LM1283 also features an internal spot killer circuit to protect the CRT when the monitor is turned off. For applications without OSD insertion please refer to the LM1205 or LM1208 data sheets. n n n n n n n n n TTL OSD inputs, 50 MHz bandwidth On chip blanking, outputs under 0.1 V when blanked Video/OSD switch speed of 7 ns Independent drive control for each channel for color balance 0V to 4V, high impedance DC contrast control with over 40 d B range 0V to 4V, high impedance DC drive control (0 d B to - 12 d B range) 0V to 4V, high impedance DC OSD contrast control with over 40 d B range Capable of 6.5 VPP output swing (slight reduction in bandwidth) Output stage directly drives most hybrid or discrete CRT drivers Applications n High resolution RGB CRT monitors requiring OSD capability Features n Three wideband video amplifiers 140 MHz @ - 3 d B (4 VPP output) Block and Connection Diagram DS012684-1 FIGURE 1. Order Number LM1283N See NS Package Number N28B © 1999 National Semiconductor Corporation DS012684 .national. Absolute Maximum Ratings (Note 1) If Military/Aerospace specified devices are required, please contact...