LMV116 Datasheet | National Semiconductor

Description The LMV116 (single) rail-to-rail output voltage feedback amplifiers offer high speed (45MHz), and low voltage operation (2.7V) in addition to micro-power shutdown capability (LMV118). Output voltage range extends to within 20m V of either supply rail, allowing wide dynamic range especially in low voltage applications. Even with low supply current of 600µA, output current capability is kept at a respectable ± 20m A for driving heavier loads. Important device parameters such as BW, Slew Rate and output current are kept relatively independent of the operating supply voltage by a bination of process enhancements and design architecture. For portable applications, the LMV118 provides shutdown capability while keeping the turn-off current to l5µA. Both turn-on and turn-off characteristics are well behaved with minimal output fluctuations during transitions. This allows the part to be used in power saving mode, as well as multiplexing applications. Miniature packages (SOT23-5 & SOT23-6) are further means to ease the adoption of these low power high speed devices in applications where board area is at a premium. Features (VS = 2.7V, TA = 25˚C, RL = 1kΩ to V+/2, AV = +1. Typical values unless specified). n - 3d B BW 45MHz n Supply voltage range 2.7V to 12V n Slew rate 40V/µs n Supply current 600µA n Power down supply current 15µA n Output short circuit current 32m A ± 20m A n Linear output current n Input mon mode voltage - 0.3V to 1.7V n Output voltage swing 20m V from rails n Input voltage noise 40n V/ n Input current noise 0.75p A/ Applications n n n n n n High speed clock buffer/driver Active filters High speed portable devices Multiplexing applications (LMV118) Current sense amplifier High speed transducer amplifier Typical Application Non-Inverting Clock Buffer Amplifier © 2003 National Semiconductor Corporation DS200807 .national. LMV116/LMV118 Absolute Maximum Ratings (Note 1) Soldering Information Infrared or Convection (20 sec) Wave...