Datasheet4U Logo Datasheet4U.com

NJM2902 - QUAD SINGLE-SUPPLY OPERATIONAL AMPLIFIER

General Description

operational amplifiers that are designed for single-supply operation.

Operation from split power supplies is also possible and the low power supply drain is independent of the magnitude of the power supply voltage.

Key Features

  • S.
  • Single Supply.
  • Operating Voltage.
  • High Output Voltage.
  • Slew Rate.
  • Low Operating Current.
  • Package Outline.
  • Bipolar Technology ( +3V~+32V ) ( V+-2V ) ( 0.5V/μs typ. ) ( 1mA typ. ) DIP14, DMP14, SSOP14.
  • PIN.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
NJM2902B Operational Amplifier Nisshinbo
NJM2902V-TE1 Quad Single Supply Operational Amplifier ETC

Other Datasheets by New Japan Radio

Part Number Description
NJM2902C QUAD SINGLE-SUPPLY OPERATIONAL AMPLIFIER
NJM2902CA QUAD SINGLE-SUPPLY OPERATIONAL AMPLIFIER
NJM2900 Quad Current Mode Single-Supply Operational Amplifier
NJM2900E Quad Current Mode Single-Supply Operational Amplifier
NJM2900M Quad Current Mode Single-Supply Operational Amplifier
NJM2900N Quad Current Mode Single-Supply Operational Amplifier
NJM2901 (Automotive) SINGLE-SUPPLY QUAD COMPARATOR
NJM2901 SINGLE-SUPPLY QUAD COMPARATOR
NJM2901C SINGLE-SUPPLY QUAD COMPARATOR
NJM2901CA SINGLE-SUPPLY QUAD COMPARATOR

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
NJM2902 QUAD SINGLE-SUPPLY OPERATIONAL AMPLIFIER ■ GENERAL DESCRIPTION The NJM2902 consists of four independent high-gain operational amplifiers that are designed for single-supply operation. Operation from split power supplies is also possible and the low power supply drain is independent of the magnitude of the power supply voltage. Used with a dual supply the circuit will operate over a wide range of supply voltages. However, a large amount of crossover distortion may occur with loads to ground. An external current-sinking resistor to-VS will reduce crossover distortion. There is no crossover distortion problem in single-supply operation if the load is direct-coupled to ground.