NX29F010 Datasheet | NexFlash

FEATURES - Ultra-fast Performance - 35, 45, 55, 70, and 90 ns max. access times - Temperature Ranges - mercial 0oc-70oc - Industrial -40oc-85oc - Single 5V-only Power Supply - 5V ± 10% for Read, Program, and Erase - CMOS Low Power Consumption - 20 m A (typical) active read current - 30 m A (typical) Program/Erase current - patible with JEDEC-Standard Pinouts - 32-pin DIP, PLCC, TSOP - Program/function patible with AM29F010 - No system firmware changes - Uses same PROM programer algorithm - Flexible sector architecture - Erase any of eight uniform sectors or full chip erase - Sector protection/unprotection using PROM programming equipment - 100,000 Program/Erase cycles - Embedded algorithms - Automatically programs and verifies data at specified address - Auto-programs and erases the chip or any designated sector - Data/Polling and Toggle Bits - Detect program or erase cycle pletion JUNE 2000 DESCRIPTION The Nex Flash NX29F010 is a 1 Megabit (131,072 bytes) single 5.0V-only Sectored Flash Memory. The NX29F010 provides in-system programming with the standard system 5.0V-only Vcc supply and can be programmed or erased in standard PROM programmers. The NX29F010 offers access times of 35, 45, 55, 70, and 90 ns allowing high-speed controller and DSPs' to operate without wait states. Byte-wide data appears on DQ0-DQ7. Separate chip enable (CE), write enable (WE), and output enable (OE) controls eliminates bus contention. Power consumption is greatly reduced when the system places the device into the Standby Mode. The device is offered in 32-pin PLCC, TSOP, and PDIP packages. Principles of Operation Only a single 5.0V power supply is required for both read and write functions. Program or erase operations do not require 12.0V VPP. Internally generated and regulated voltages are provided for the program and erase operations. The device is entirely mand set patible with the JEDEC single power supply Flash standard. mands are written to the mand register using standard...