UZS1A100MCL Datasheet | Nichicon

ALUMINUM ELECTROLYTIC CAPACITORS 4.5mm L Chip Type series Chip type with 4.5mm height. Designed for surface mounting on high density PC board. Applicable to automatic mounting machine using carrier tape. Adapted to the Ro HS directive (2002/95/EC). Smaller High Te m p e rature Smaller Bi-polarized Specifications Item Category Temperature Range Rated Voltage Range Rated Capacitance Range Capacitance Tolerance Leakage Current tan δ Performance Characteristics - 40 ~ + 85°C 4 ~ 50V 0.1 ~ 220µF + - 20% at 120Hz, 20°C After 2 minutes' application of rated voltage, leakage current is not more than 0.01 CV or 3 (µA) ,whichever is greater. Measurement frequency : 120Hz, Temperature : 20°C Rated voltage (V) tan δ (MAX.) 4 0.50 6.3 0.30 10 0.24 16 0.19 25 0.16 35 0.14 50 0.14 Measurement frequency : 120Hz Stability at Low Temperature Rated voltage (V) Z- 25°C / Z+20°C Impedance ratio ZT / Z20 (MAX.) Z- 40°C / Z+20°C 4 7 15 6.3 4 8 10 3 8 16 2 4 25 2 4 35 2 3 50 2 3 Endurance After 2000 hours' application of rated voltage at 85°C,capacitors meet the characteristics requirements listed at right. Capacitance change tan δ Leakage current Within + - 20% of initial value 200% or less of initial specified value Initial specified value or less Shelf Life Resistance to soldering heat Marking After storing the capacitors under no load at 85°C for 1000 hours, and after performing voltage treatment based on JIS C 5101-4 clause 4.1 at 20°C, they will meet the specified value for endurance characteristics listed above. The capacitors shall be kept on the hot plate maintained at 250°C Capacitance change Within + - 10% of initial value for 30 seconds. After removing from the hot plate and restored tan δ Initial specified value or less at room temperature,they meet the characteristic requirements Initial specified value or less Leakage current listed at right. Black print on the case top. Chip Type Positive 0.5 MAX. Capacitance Lot No. Voltage...