AMIS-52150 Datasheet | onsemi

features , such as dual independent receive channels, Quick Start crystal oscillator, Sniff Mode signal acquisition, and data clock recovery, the AMIS- 52150 is ideally suited for a wide range of applications, including point-to-point wireless data links, cost-optimized wireless monitor solutions, and very low power remote wireless sensors, among others. http://onsemi. SSOP- 20 CASE TBD Key Features - Data Clock Recovery - Auto Slicing of Data - Very Low-power Single-chip Transceiver - Minimal External ponents - Low-power RC Oscillator - Quick Start Crystal Oscillator - Ultra-low Power RF Sniff Mode, with Wake-up on RSSI - Internal Trim Functions Reduce External ponent Requirements - I2C Control Interface ORDERING INFORMATION See detailed ordering and shipping information in the package dimensions section on page 20 of this data sheet. - Serial TX/RX Data Port - Clock Generation for an External Microprocessor - Wake-up on RSSI - Antenna Diversity Dual Receiver - Internal VCO/PLL Tuning Varactor - Wake-up Interrupt to External Controller - These Devices are Pb-Free and are Ro HS pliant Technical Features - Operating Frequency Range:  Quick Start, from 350 MHz to 448 MHz  Non-quick Start, from 300 MHz to 768 MHz - TX Output Power: +12 d Bm - RX Sensitivity:  Sniff Mode: - 93 d Bm Minimum  Receive: - 117 d Bm Minimum @ 1 kbps, with CDR - Data Rate:  1- 8 kbps with Manchester Coding  1- 16 kbps with NRZ Data - Power Requirements:  Receive: 7.5 m A (Continuous)  Transmit: 25 m A @ Full Power (50% Duty-cycle)  Sniff Mode: 75 m A (One Percent Duty-cycle)  Standby: 500 n A (RC Oscillator Running) - Operating Voltage: 2.3 V to 3.6 V - Modulation: ASK/OOK - Xtal Start Time: 15 ms (Quick Start) - Sniff Mode Polling: 0.5 ms to 16...