Datasheet4U Logo Datasheet4U.com

OCP8110 - 500mA Buck/Boost Charge Pump LED Driver

General Description

The OCP8110 is current-regulated charge pump ideal for powering high brightness LEDs for camera flash applications.

The charge pump can be set to regulate two current levels for FLASH and TORCH modes.

Key Features

  • a very low shutdown current (less than 1uA), an automatic soft-start mode to limit inrush current, as well as over current, over voltage and over temperature shutdown control. A Low current sense reference voltage (50mV) allows the user of small 0603 current sensing resistors. The OCP8110 is offere.

📥 Download Datasheet

Datasheet Details

Part number OCP8110
Manufacturer Orient Chip
File Size 232.96 KB
Description 500mA Buck/Boost Charge Pump LED Driver
Datasheet download datasheet OCP8110 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
OCP8171 CABC Compatible High Efficiency Boost LED Backlight Driver ORIENT-CHIP
OCP8178 White LED Driver ORIENT-CHIP
OCP8178A White LED Driver ORIENT-CHIP
OCP-PCP116 SIX PIN DIP SINGLE CHANNEL PHOTO IC PHOTOCOUPLER ETC
OCP-PCT4116 Transistor/Diode Output Optocoupler Lumex Opto Components

Other Datasheets by Orient Chip

Part Number Description
OCP8110A 500mA Buck/Boost Charge Pump LED Driver
OCP8111 1.0A Buck/Boost Charge Pump LED Driver
OCP8111A 1.0A Buck/Boost Charge Pump LED Driver
OCP8113 1.3A Buck/Boost Charge Pump LED Driver
OCP8107 One-Channel High Power LED Controller

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
WWW.ORIENT-CHIP.COM OCP8110 500mA Buck/Boost Charge Pump LED Driver ◼ General Description The OCP8110 is current-regulated charge pump ideal for powering high brightness LEDs for camera flash applications. The charge pump can be set to regulate two current levels for FLASH and TORCH modes. The OCP8110 automatically switches modes between step-up and step-down ensuring that LED current does not depend on the forward voltage. It switches at 1.8MHz, allowing the use of tiny components. The supply voltage ranges from 2.7V to 5.5V and is ideally suited for all applications powered by a single Li_Ion battery cell or three to four NiCd, NiMH, or Alkaline battery cells.