CP1006 Datasheet | Pan Jit International Inc.

FEATURES l Surge overload rating- 200 Amperes peak l Low forward voltage drop and reverse leakage l l l Small size, simple installation Plastic package has Underwriter Laboratory Flammability Classification 94V-O Reliable low cost construction utilizing molded plastic technique MECHANICAL DATA Case: Molded plastic with heatsink integrally mounted in the bridge encapsulation Terminals: Leads solderable per MIL-STD-202, Method 208 Weight: 0.21 ounce, 6.1 grams MACXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS At 25 ¢J ambient temperature unless otherwise noted; resistive or inductive load at 60Hz . Max Recurrent Peak Rev Voltage Max Bridge Input Voltage RMS Max Average Rectified Output at TC=50 ¢J - See Fig. 2 at TC=100 ¢J - at TA=50 ¢J - - Peak One Cycle Surge Overload Current Max Forward Voltage Drop per element at 5.0A DC & 25 ¢J . See Fig. 3 Max Rev Leakage at rated Dc Blocking Voltage per element at 25 ¢J See Fig 4 at100 ¢J Typical junction capacitance per leg (Note 4) CJ CP-10 CP1000 CP1001 CP1002 CP1004 CP1006 CP1008 UNITS 50 100 200 400 600 800 V 35 70 140 280 420 560 V 10.0 A 3.0 A 3.0 200 1.1 A V 10.0 1.0 200 164 25 5 -55 TO +125 -55 TO +150 I t Rating for fusing ( t<8.3ms) Typical Thermal Resistance (Note 2) R £K JA Typical Thermal Resistance (Note 3) R £K JC Operating Temperature Range Storage Temperature Range £g A m A PF 2 AS ¢J /W ¢J ¢J NOTES: - Unit mounted on metal chassis. - - Unit mounted on P.C. board. 1. Remended mounting position is to bolt down on heatsink with silicone thermal pound for maximum heat transfer with #6 screw. 2. Units Mounted in free air, no heatsink. P.C.B at 0.375”(9.5mm) lead length with 0.5 ¡Ñ 0.5” (12 ¡Ñ 12mm)copper pads. 3. Units Mounted on a 3.0 ¡Ñ 3.0” ¡Ñ 0.11” thick (7.5 ¡Ñ 7.5 ¡Ñ 0.3cm) AL plate heatsink. 4. Measured at 1.0MHZ and applied reverse voltage of 4.0 volts. RATING AND CHARACTERISTIC CURVES CP1000 THRU CP1008 FORWARD SURGE CURRENT, AMPERES pk (HALF SINE WAVE) 200 160 120 80 T A = 105 ¢J 40 0 1 2 6 10 20...