DGP30E48S15 Datasheet | Power-One

DGP30 SERIES SINGLE OUTPUT DESCRIPTION The single output DGP30 Series is designed to accept an extended 2:1 input voltage range for use in industrial and tele applications. The output of the converter is electrically isolated, thereby allowing the output to be configured as a positive or negative output voltage. For additional system utility output Trim and Remote ON/OFF are featured. Overcurrent protection, overtemperature protection, and output overvoltage transient protection allow safe, reliable operation. Features - Remote ON/OFF and TRIM - Low OFF Current - Overcurrent and Overtemperature Protection - Efficiencies to 86% - Transient Output Overvoltage Protection - 1544V Isolation - Five-Side Shielded Case - Extended Range Input (2:1) BOTTOM VIEW 2.02 (51.31) SIDE VIEW 0.040 (1.02) DIA 6 PLACES 0.700 (17.78) 0.600 (15.24) 0.400 (10.16) 0.300 (7.62) 0.000 0.100 (2.54) 0.31 (7.9) 0.11 (2.8) 0.000 5 1 2 6 1.62 (41.15) 0.3 (7.62) 1.800 (45.72) Mechanical tolerances unless otherwise noted: X.XX dimensions: ±0.020 inches X.XXX dimensions: ±0.005 inches NOTES (1) All parameters measured at Tc = 25°C, nominal input voltage and full rated load unless otherwise noted. Refer to the Technical Reference Section for the definition of terms, measurement circuits and other information. (2) ON/OFF pin is referenced to pin 2, -Input. See DGP30 Series Application Notes for the specific requirements of this feature. (3) The Case is electrically connected to Pin 1, +Input. (4) Full output trim range may not be available at minimum input voltage and full load. Full trim is guaranteed from minimum input voltage, plus 5%, and full load. (5) The case thermal impedance is specified as the case temperature rise over ambient per package watt dissipated. Rev. 04/2000 0.55 (13.97) DGP30 SERIES - SINGLE OUTPUT NOTES (1) All parameters measured at Tc=25 °C case temperature, nominal input voltage and full rated load unless otherwise noted. Refer to the Technical...