Programmable Microelectronics PM25LV512
The Pm25LV512/010 are 512 Kbit/1 Mbits 3.0 Volt-only serial Flash memories. These devices are designed to use a single low voltage, range from 2.7 Volt to 3.6 Volt, power supply to perform read, erase and program operations. The devices can be programmed in standard EPROM programmers as well.| Part No. | PM25LV512 |
|---|---|
| Datasheet | PM25LV512 Download |
| Manufacturer |  Programmable Microelectronics |
| Description | Serial Flash Memory |
| Buy | Stock & Price |
FEATURES
Single Power Supply Operation - Low voltage range: 2.7 V - 3.6 V● Memory Organization - Pm25LV512: 64K x 8 (512 Kbit) - Pm25LV010: 128K x 8 (1 Mbit) Cost Effective Sector/Block Architecture - Uniform 4 Kbyte sectors - Uniform 32 Kbyte blocks (8 sectors per block) - Two blocks with 32 Kbytes each (512 Kbit) - Four blocks with 32 Kbytes each (1 Mbit) - 128 pages per block Pm25LV512 / Pm25LV010 512 Kbit / 1 Mbit 3.0 Volt-only, Serial Flash Memory With 25 MHz SPI Bus Interface Block Write Protection - The Block Protect (BP1, BP0) bits allow part or entire of the memory to be configured as read-only. Hardware Data Protection - Write Protect (WP#) pin will inhibit write operations to the status register
● Page Program (up to 256 Bytes) - Typical 2 ms per page program time Serial Peripheral Interface (SPI) Compatible - Supports SPI Modes 0 (0,0) and 3 (1,1) High Performance Read - 25 MHz clock rate (maximum) Page Mode for Program Operations - 256 bytes per page
GENERAL DESCRIPTION
The device is optimized for use in many commercial applications where low-power and low-voltage operation are essential.
