Datasheet4U Logo Datasheet4U.com

DNT90PA - (DNT90CA/PA) 900 MHz Frequency Hopping Spread Spectrum Transceiver

This page provides the datasheet information for the DNT90PA, a member of the DNT90CA (DNT90CA/PA) 900 MHz Frequency Hopping Spread Spectrum Transceiver family.

Datasheet Summary

Description

Pin 1 Name GND ACT (DIAG_TX) I/O O (O) Description Power supply and signal ground.

Connect to the host circuit board ground.

This pin’s default configuration is data activity output.

📥 Download Datasheet

Datasheet preview – DNT90PA

Datasheet Details

Part number DNT90PA
Manufacturer RF Monolithics
File Size 248.31 KB
Description (DNT90CA/PA) 900 MHz Frequency Hopping Spread Spectrum Transceiver
Datasheet download datasheet DNT90PA Datasheet
Additional preview pages of the DNT90PA datasheet.

📁 Similar Datasheet

  • DNT90 - Low Cost 900 MHz FHSS Transceiver (Murata)
  • DNT04 - Non-Isolated Point of Load DC/DC Power Modules (Delta Electronics)
  • DNT2400 - Low Cost 2.4 GHz FHSS Transceiver Module (Murata)
Other Datasheets by RF Monolithics
  • DNT90CA - (DNT90CA/PA) 900 MHz Frequency Hopping Spread Spectrum Transceiver

Full PDF Text Transcription

Click to expand full text
- 900 MHz Frequency Hopping Spread Spectrum Transceiver - Point-to-point, Point-to-multipoint, Peer-to-peer and Store & Forward Capabilities - Transmitter Power Configurable to 40 or 158 mW - Built-in 0 dBi Chip Antenna - 100 kbps RF Data Rate - 128-Bit AES Encryption - Separate Serial Port for Diagnostics - Analog and Digital I/O for Sensor Applications - FCC and Canadian IC Certified for Unlicensed Operation The DNT90CA/PA FHSS transceiver modules provides a low-cost, versatile solution for wireless data communications in the 900 MHz ISM band. The DNT90CA/PA RF output power can be set at 40 or 158 mW. The DNT90CA/PA receiver input is protected by low-loss SAW filter, providing an excellent combination of receiver sensitivity and out-of-band interference rejection.
Published: |