5P49V5923 Datasheet | Renesas

Programmable Clock Generator Description The 5P49V5923 is a programmable clock generator intended for high performance consumer, networking, industrial, puting, and data-munications applications. Configurations may be stored in on-chip One-Time Programmable (OTP) memory or changed using I2C interface. This is IDT’s fifth generation of programmable clock technology (Versa Clock® 5). The frequencies are generated from a single reference clock. The reference clock can e from one of the two redundant clock inputs. A glitchless manual switchover function allows one of the redundant clocks to be selected during normal operation. Two select pins allow up to 4 different configurations to be programmed and accessible using processor GPIOs or bootstrapping. The different selections may be used for different operating modes (full function, partial function, partial power-down), regional standards (US, Japan, Europe) or system production margin testing. The device may be configured to use one of two I2C addresses to allow multiple devices to be used in a system. Pin Assignment OUT0_SEL_I2CB VDDO0 VDDD VDDO1 OUT1 NC CLKIN CLKINB XOUT XIN/REF VDDA CLKSEL 1 24 23 19 18 2 17 EPAD 5 14 6 13 7 8 9 10 11 12 VDDO2 OUT2 NC VDDA NC NC Features - Generates up to two independent output frequencies - High performance, low phase noise PLL, <0.7 ps RMS typical phase jitter on outputs - Two fractional output dividers (FODs) - Independent Spread Spectrum capability on each output - Four banks of internal non-volatile in-system programmable or factory programmable OTP memory - I2C serial programming interface - Three LVCMOS outputs, including one reference output - I/O Standards: - Single-ended I/Os: 1.8V to 3.3V LVCMOS - Input frequency...