Overview: HIP1013 NOT REMENDED FOR NEW DESIGNS NO REMENDED REPLACEMENT
c1o-8n8t8a-cItNoTuErRTSeIcLhonricwawl Swu.ipnpteorrstiCl.ceonmte/rtsact Low Cost Dual Power Distribution Controller DATASHEET
FN4516 Rev 3.00 August 2004 The HIP1013 is a low cost HOT SWAP dual supply power distribution controller. Two external N-Channel MOSFETs are driven to distribute power while providing load fault isolation. At turn-on, the gate of each external N-Channel MOSFET is charged with a 10A current source. Capacitors on each gate (see the Typical Application Diagram), create a programmable ramp (soft turn-on) to control inrush currents. A built in charge pump supplies the gate drive for the 12V supply N-Channel MOSFET switch.
Over current protection is facilitated by two external current sense resistors. When the current through either resistor exceeds the user programmed value the N-Channel MOSFETs are latched off by the HIP1013. The controller is reset by a rising edge on either PWRON pin. Choosing the voltage selection mode the HIP1013 controls either +12V/5V or +3.3V/+5V supplies.
Although pin patible with the HIP1012 device, the HIP1013 does not offer current regulation during an OC event. Ordering Information PART NUMBER
HIP1013CB TEMP. RANGE (°C)
-0 to 70 PACKAGE 14 Ld SOIC PKG. DWG. #
M14.15 HIP1013CBZA (Note) -0 to 70 14 Ld SOIC (Pb-free) M14.15 NOTE: Intersil Pb-free products employ special Pb-free material sets; molding pounds/die attach materials and 100% matte tin plate termination finish, which is patible with both SnPb and Pb-free soldering operations. Intersil Pb-free products are MSL classified at Pb-free peak reflow temperatures that meet or exceed the Pb-free requirements of IPC/JEDEC J Std-020B.
*Tape & Reel packaging available with “-T” suffix..
