X9116 - Digitally Potentiometer

Renesas

General Description

VH /RH and VL /RL The high (VH/RH) and low (VL/RL) terminals of the X9116 are equivalent to the fixed terminals of a mechanical potentiometer.

The minimum voltage is VSS and the maximum is VCC.

Key Features

Solid-state nonvolatile.
16 wiper taps.
3-wire up/down serial interface.
VCC = 2.7V and 5V.
Active current < 50µA max.
Standby current < 5µA max.
RTOTAL = 10k.
Packages: 8 Ld MSOP, 8 Ld SOIC.
Pb-free plus anneal available (RoHS compliant) Pinout SOIC/MSOP INC U/D VH/RH VSS 1 2 X9116 3 4 8 7 6 5 VCC CS VL/RL VW/RW Block Diagram VCC (Supply Voltage) Up/Down (U/D) Increment (INC) Device Select (CS) Control.

📥 Download Datasheet

X9116 digitally potentiometer by Renesas - Datasheet Preview

Datasheet Details

Part number	X9116
Manufacturer	Renesas
File Size	467.39 KB
Description	Digitally Potentiometer
Datasheet	X9116 Datasheet

📁 Similar Datasheet

Brand Logo	Part Number	Description	Manufacturer
	X9116	Digitally Controlled Potentiometer (XDCP)	Xicor

More Datasheets from Renesas

Part Number	Description
X9110	Single Digitally Potentiometer
X9111	Single Digitally Potentiometer
X9118	Dual Supply/Low Power/1024-Tap/2-Wire Bus Single Digitally-Controlled Potentiometer
X9119	Digitally Potentiometer

Full PDF Text Transcription for X9116 (Reference)

Note: Below is a high-fidelity text extraction (approx. 800 characters) for X9116. For precise diagrams, tables, and layout, please refer to the original PDF.

DATASHEET X9116 Low Noise, Low Power, Low Cost Digitally Controlled Potentiometer (XDCP™) FN8160 Rev...

View more extracted text

3.00 February 3, 2011 The Intersil X9116 is a digitally controlled nonvolatile potentiometer designed to be used in trimmer applications. The pot consists of 15 equal resistor segments that connect to the wiper pin through programmable CMOS switches. The tap position is programmed through a 3-wire up/down serial port. The last position of the wiper is stored in a nonvolatile memory location which is recalled at the time of power up of the device. The wiper moves through sequential tap positions with inputs on the serial port. A falling edge on INC (bar) causes the tap position to increment one position up or down based on whether the U/D (bar) pin is held high or low.