JB1010
Description
The JB1010 is a summing junction box and trimming device for up to ten strain gauge load cells. In new applications that use a single junction box, the JB1010 can be custom configured to fit many unique applications.
Key Features
- 0 General Wiring Guidelines The JB1010 is a universal trimming board, designed to trim almost any set of new or existing load cells in nearly any configuration. To properly wire the JB1010, first determine what kind of application you have. If the JB1010 is the only trimming junction box in a new system, continue on to the next page. If the JB1010 replaces one or more boards in an existing system, skip to Section 8.0. 2 Wire Preparation The JB1010 uses spring-loaded, quick-connect wire terminals. These connectors are very reliable if used properly. To prepare the wires, strip 3/8" of insulation from the individual wires. If the conductors are stranded wires, tin the ends of the wires using wire solder with a non-corrosive solder flux. Inserting the Wires into the Terminals Push down on the plastic lever with a pen or small screwdriver to compress the spring. See Figure 3-1. Install the wire into the compression clamps. Push the wire into the connector until the wire is fully seated. Make sure the clamp is resting on the stripped portion of the wire and not on the insulation. Release the lever and pull on the wire to make sure it is secure.
