Datasheet4U Logo Datasheet4U.com

BA3714F - 1.5V signal sensor

Features

  • 1) Operation possible at ultra-low voltages. (VCC = 0.8 to 4.5V) 2) Minimal attached components. 3) Uses dual rectified current method for excellent signal response. FAbsolute maximum ratings (Ta = 25_C) 4) Very low current dissipation. (IQ = 0.9mA) 5) When used for a tape end sensor, can also be used with mechanical auto-off. 6) SOP 8-pin package allows space conservation on the board. FRecommended operating conditions (Ta = 25_C) 746 Audio ICs FBlock diagram BA3714F FElectrical character.

📥 Download Datasheet

Datasheet preview – BA3714F

Datasheet Details

Part number BA3714F
Manufacturer ROHM
File Size 45.21 KB
Description 1.5V signal sensor
Datasheet download datasheet BA3714F Datasheet
Additional preview pages of the BA3714F datasheet.

📁 Similar Datasheet

  • BA301 - DC to DC Converter (XP Power)
  • BA301N - SMD Gas Discharge Tube (Bencent)
  • BA301N-D - Gas Discharge Tube (Bencent)
  • BA3060 - Fast silicon rectifier diodes (Semikron International)
  • BA314 - Low-voltage stabistor (NXP)
  • BA315 - Low-voltage stabistor (NXP)
  • BA316 - High-speed diodes (NXP)
  • BA317 - High-speed diodes (NXP)
  • BA318 - High-speed diodes (NXP)
  • BA3308 - DUAL PREAMPLIFIER (UTC)
Other Datasheets by Rohm
  • BA3703F - Mute detector IC
  • BA3707 - Mute detector
  • BA3708F - Mute detector IC for 3V sets
  • BA30BC0FP - 1.0A Low-Dropout Voltage Regulator
  • BA30BC0T - 1A Variable/Fixed Output LDO Regulators
  • BA30BC0WFP - 1A Variable/Fixed Output LDO Regulators
  • BA30BC0WFP-E2 - 1A Variable/Fixed Output LDO Regulators
  • BA30BC0WT - 1A Variable/Fixed Output LDO Regulators

Full PDF Text Transcription

Click to expand full text
Audio ICs 1.5V signal sensor BA3714F The BA3714F is a signal sensor consisting of a sensor circuit which detects the presence of an input signal, a logic circuit which controls an output drive circuit based on the input signal, and an output drive circuit. The signal sensor circuit employs the dual-wave rectified current method for excellent response. The outputs TE of Pin 3 and TON of Pin 5 can be respectively set by choosing appropriate values for the capacitor between Pin 7 and VCC and the capacitor between Pin 1 and ground. Drive outputs include two systems OUT1 and OUT which are controlled by the logic block. These systems can be combined to enable a wide range of designs. FApplications Tape end sensors for 1.
Published: |