Datasheet4U Logo Datasheet4U.com

ST95022 - 2 Kbit Serial SPI EEPROM with High Speed Clock

General Description

The ST95022 is an high speed 2 Kbit Electrically Erasable Programmable Memory (EEPROM) fabricated with STMicroelectronics’s High Endurance Single Polysilicon CMOS technology.

The memory is accessed by a simple SPI bus compatible serial interface.

Key Features

  • he rising edge.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
ST950-30L2MI Wet Tantalum Capacitors Vishay
ST95HF Near field communication transceiver STMicroelectronics
ST90-125L2MI Wet Tantalum Capacitors Vishay
ST9011 NPN Silicon Epitaxial Planar Transistor SEMTECH
ST9012 PNP Silicon Epitaxial Planar Transistor SEMTECH

Other Datasheets by STMicroelectronics

Part Number Description
ST95020 (ST950x0) 4K/2K/1K Serial SPI EEPROM with Positive Clock Strobe
ST95010 (ST950x0) 4K/2K/1K Serial SPI EEPROM with Positive Clock Strobe
ST95040 (ST950x0) 4K/2K/1K Serial SPI EEPROM with Positive Clock Strobe
ST952 D.A.A. LINE INTERFACE
ST95P02 SERIAL ACCESS SPI BUS 2K 256 x 8 EEPROM

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
ST95022 2 Kbit Serial SPI EEPROM with High Speed Clock HIGH SPEED CLOCK RATE: – 2.1 MHz Max 1,000,000 ERASE/WRITE CYCLES 40 YEARS DATA RETENTION SINGLE 4.5V to 5.5V SUPPLY VOLTAGE SPI BUS COMPATIBLE SERIAL INTERFACE BLOCK WRITE PROTECTION STATUS REGISTER 16 BYTE PAGE MODE WRITE PROTECT SELF-TIMED PROGRAMMING CYCLE E.S.D.PROTECTION GREATER than 4000V SUPPORTS POSITIVE CLOCK SPI MODES 8 1 SO8 (M) 150mil Width Figure 1. Logic Diagram DESCRIPTION The ST95022 is an high speed 2 Kbit Electrically Erasable Programmable Memory (EEPROM) fabricated with STMicroelectronics’s High Endurance Single Polysilicon CMOS technology. The memory is accessed by a simple SPI bus compatible serial interface. The bus signals are a serial clock input (C), a serial data input (D) and a serial data output (Q).