CLP200M Datasheet | STMicroelectronics

DESCRIPTION The CLP200M is designed to protect telemunication equipment.It provides both a transient overvoltage protection and an overcurrent protection. It is housed in a Power SO-10TM package. FEATURES DUAL BIDIRECTIONAL PROTECTION DEVICE. HIGH PEAK PULSE CURRENT : Ipp = 100A (10/1000 µs SURGE) MAX. VOLTAGE AT SWITCHING-ON : 290V MIN. CURRENT AT SWITCHING-OFF : 150m A FAILURE STATUS OUTPUT PIN BENEFITS Both primary and secondary protection levels in one device. Voltage and current controlled suppression. Surface Mounting with Power SO-10TM package. Line card cost reduction thanks to the very low power rating of external ponents required : balanced resistors, ring relay, low voltage SLIC protection. PLIESWITH THE FOLLOWINGSTANDARDS : 10 / 700µs 5 / 310µs BELLCORE TR-NWT-000974 10 / 1000µs 10 / 1000µs CCITT K20 : 4k V 100 A 1k V 100A TAB is connected to GND Power SO-10TM SCHEMATIC DIAGRAM FS TIP S TIP L TIP L TIP L NC RING S RING L RING L RING L February 1998 Ed : 3 1/21 BLOCK DIAGRAM TIPL TIPS Overcurrent detector OR SW3 FS SW4 SW2 OR SW1 Overvoltage detector Overvoltage reference (+/- 215 V) Overvoltage detector Overvoltage reference (+/- 215 V) Overcurrent detector RINGL RINGS Pin 1 2 3/ 4/ 5 6/ 7/ 8 9 10 TAB Symbol FS TIPS TIPL RINGL RINGS NC GND Description Failure Status TIP (SLIC side) TIP (Line side) RING (Line side) RING (SLIC side) Not connected Ground 2/21 ® APPLICATION NOTE 1. INTRODUCTION The aim of this section is to show the behavior of our new tele line protectiondevice. This device includes a primary protection level and is suitable for main distribution frames and line cards. This protection concept is explained and, in addition, the CLP200M performances are analysed when facing different surges as described in the CCITT remendations. Fig. 1 : Subscriber line protection topology 2. SGS-THOMSON CLP200M CONCEPT 2.1 Evolution of the SLIC protection Over the years, the silicon protection performances have...