ST7LITE30F2 Datasheet | STMicroelectronics

Features - Memories - 8 Kbytes program memory: single voltage extended Flash (XFlash) Program memory with read-out protection, In-Circuit Programming and In-Application programming (ICP and IAP), data retention: 20 years at 55°C. - 384 bytes RAM - 256 bytes data EEPROM with read-out protection. 300K write/erase cycles guaranteed, data retention: 20 years at 55°C. - Clock, Reset and Supply Management - Enhanced reset system - Enhanced low voltage supervisor (LVD) for main supply and an auxiliary voltage detector (AVD) with interrupt capability for implementing safe power-down procedures - Clock sources: Internal RC 1% oscillator, crystal/ceramic resonator or external clock - Optional x4 or x8 PLL for 4 or 8 MHz internal clock - Five Power Saving Modes: Halt, Active-Halt, Wait and Slow, Auto Wake Up From Halt - I/O Ports - Up to 15 multifunctional bidirectional I/O lines - 7 high sink outputs - 5 Timers - Configurable Watchdog Timer - Two 8-bit Lite Timers with prescaler, 1 realtime base and 1 input capture - Two 12-bit Auto-reload Timers with 4 PWM outputs, input capture and output pare functions QFN20 SO20 DIP20 - 2 munication Interfaces - Master/slave LINSCI™ asynchronous serial interface - SPI synchronous serial interface - Interrupt Management - 10 interrupt vectors plus TRAP and RESET - 12 external interrupt lines (on 4 vectors) - A/D Converter - 7 input channels - 10-bit resolution - Instruction Set 8-bit data manipulation - 63 basic instructions with illegal opcode detection - 17 main addressing modes - 8 x 8 unsigned multiply instructions - Development Tools - Full hardware/software development package - DM (Debug module) Table 1. Device summary Features Program...