LV58132MX Datasheet | SANYO

.Data Sheet.co.kr Ordering number : ENA1924 Bi-CMOS IC Overview Step-down Switching Regulator LV58132MX is a 1ch step-down switching regulator. With built-in 0.25Ω power MOSFET switch, it achieves high output current and high efficiency. With low-heat resistance, miniature package MFP8 (200mil) with heat-sink is adopted. Since it is Current mode control type, it has good load current response, and phase pensation is easy. With ON/OFF pin, operating can be less than 90μA at stand-by mode. It has over current protection for load devices. With external capacitor, it achieves soft start. Functions - 2.0A 1ch step-down regulator - Small package: MFP8 (200mil) with heat sink - High efficiency (88% IOUT = 1A, VIN = 12V, VO = 5V) - Standby mode - Over-current protection - Thermal shutdown protection - Reference voltage: 0.8V - Inside frequency: 370k Hz - Soft start - Wide input dynamic range (4.75 to 18V) Specifications Parameter Maximum Ratings at Ta = 25°C Symbol VIN max VBT max VSW max VBS-SW max VEN max Vfs max Pd max Tj max Topr Tstg Mount on a specified board - 1 Conditions Ratings 20 25 VIN max 7 20 7 2.05 150 -20 to 80 -40 to 150 Unit V V V V V V W °C °C °C Maximum input VIN voltage BOOT pin maximum voltage SW pin maximum voltage BOOT pin-SW pin maximum voltage EN Maximum Voltage FB, P, SS pin maximum voltage Allowable power dissipation Junction temperature Operating temperature Storage temperature - 1: 46.4mm х 31.8mm х 1.7mm Four layers glass epoxy substrate. Note: Plan the maximum voltage while including coil and surge voltages, so that the maximum voltage is not exceeded even for an instant. Any and all SANYO Semiconductor Co.,Ltd. products described or contained herein are, with regard to "standard application", intended for the use as general electronics equipment (home appliances, AV equipment, munication device, office equipment, industrial equipment etc.). The products mentioned herein shall not be intended for use for any...