STK672-330 Datasheet | SANYO

Ordering number : ENN7304 .. Thick-Film Hybrid IC Unipolar Fixed-Current Chopper (External-Excited PWM) Scheme and Built-in Phase Signal Distribution IC Two-Phase Stepping Motor Driver (Square Wave Drive) Output Current: 1.8 A Overview The STK672-330 is a unipolar fixed-current chopper type 2-phase stepping motor driver hybrid IC. It Features power MOSFETs in the output stage and a built-in phase signal distribution IC. The incorporation of a phase distribution IC allows the STK672-330 to control the speed of the motor based on the frequency of an external input clock signal. It supports two types of excitation for motor control: 2-phase excitation and 1-2 phase excitation. It also provides a function for switching the motor direction. The STK672-330 Features an ENABLE pin, a function not provided in the STK672-110. When the ENABLE pin is set low while the clock signal is being supplied, all MOSFET devices are forced to the off state. When ENABLE is set high again later, the IC resumes operation, continuing with the prior excitation timing. - All inputs are Schmitt inputs. - The motor current can be set by changing the Vref pin voltage. Since a 0.195-Ω current detection resistor is built in, a current of 1 A is set for each 0.195 V of applied voltage. - The input frequency range for the clock signal used for motor speed control is 0 to 50 k Hz. - Supply voltage ranges: VCC1 = 10 to 42 V, VCC2 = 5.0 V ±5% - This IC supports motor operating currents of up to 1.8 A at Tc = 105°C, and of up to 2.65 A at Tc = 25°C. - Provides a function that, during clock input, forces all MOSFET devices to the off state when the ENABLE pin is set low, and then, when ENABLE is set high, resumes operation continuing with the prior excitation timing. Applications - Two-phase stepping motor drive in send/receive facsimile units - Paper feed in copiers, industrial robots, and other applications that require 2-phase stepping motor drive Package Dimensions...