35SVPD22M Datasheet | SANYO

.Data Sheet.co.kr 4. SPECIFICATIONS FOR EACH SERIES Conductive polymer type SVPD Series Guaranteed at 125°C, 85°C 85% guaranteed,Rated 35V, Rated 35V max. The SVQP series guaranteed 125°C This product is very reliable, guaranteeing 85°C 85% performance. Suitable for use in smoothing circuits of vehiclemounted equipment, industrial equipment, etc. This product can support lead free-reflow.( 2). Specifications Items Category temperature range Tolerance on rated capacitance Tangent of loss angle Leakage current 1 ESR Characteristics of impedance ratio at high temp. and low temp. Conditions Marking : Polarity( ), Rated voltage, (Purple) SVPD Rated capacitance, Lot.No. Characteristics -55°C to +125°C M : ±20% 120Hz Less than or equal to the value of Table2 120Hz Less than or equal to the value of Table2 After 2 minutes Less than or equal to the value of Table2 Z / Z 20°C 0.75 to 1.25 Based the value at -55°C 0.75 to 1.25 Z / Z 20°C 100KHz +20°C +125°C Within ±20% ∆C/C 2 times or less than an initial standard 125°C, 2,000h, Rated tanδ Endurance 2 times or less than an initial standard voltage applied ESR Leakage current Below an initial standard Within ±20% ∆C/C 85°C, 85 to 90% RH, 2 times or less than an initial standard tanδ Damp heat (Steady state) 1,000h, 2 times or less than an initial standard ESR Rated voltage applied Leakage current Below an initial standard Within ±10% ∆C/C Resistance to 1.3 times or less than an initial standard tan δ 2 (VPS) (230°C X 75s) soldering heat 1.3 times or less than an initial standard ESR Leakage current Below an initial standard (after voltage processing) 1 In case of some problems for measured values, measure after applying rated voltage for 120 minutes at 125°C . 2 Refer to Page 56 for reflow soldering conditions. Dimensions 0.2max. W (unit : mm) Size Code C6 E7 F8 E12 F12 φD±0.5 6.3 8.0 10.0 8.0 10.0 +0.1 L -0.4 5.9 6.9 7.9 11.9 12.6 W±0.2 6.6 8.3 10.3 8.3 10.3 H±0.2 6.6 8.3 10.3 8.3 10.3 C±0.2 7.3 9.0 11.0 9.0 11.0...