MCX120A - Potentiometer Cable Sensor

Download the MCX120A datasheet PDF. This datasheet also covers the MCX120A-Sauer variant, as both devices belong to the same potentiometer cable sensor family and are provided as variant models within a single manufacturer datasheet.

General Description

The Cable Sensor MCX120A uses a 10-turn potentiometer as the sensing element for length measurement.

It is designed for use as a feedback sensor in e.g.

measuring the cutting depth of a planer.

Key Features

Rugged housing.
Easy to install.
MS-connector.
Length measurement up to 400 mm.
Moisture and corrosion resistant.
Withstands vibration and shock.

📥 Download Datasheet

MCX120A potentiometer cable sensor by Sauer-Danfoss - Datasheet Preview — Note: The manufacturer provides a single datasheet file (MCX120A-Sauer-Danfoss.pdf) that lists specifications for multiple related part numbers.

Datasheet Details

Part number	MCX120A
Manufacturer	Sauer-Danfoss
File Size	81.78 KB
Description	Potentiometer Cable Sensor
Datasheet	MCX120A Datasheet

📁 Similar Datasheet

Part Number	Description	Manufacturer
MCX18LG0A	Micro Unit CCD	Sony
MCX18LG0B	Micro Unit CCD	Sony
MCX18N00A	Micro Unit CCD	Sony
MCX18N00B	Micro Unit CCD	Sony
MCX304	MOTOR CONTROL IC	ETC

Other Datasheets by Sauer-Danfoss

Part Number	Description

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text

MCX120A Potentiometer Cable Sensor Technical Information DESCRIPTION MCX120A Potentiometer Cable Sensor Technical Information Overview The Cable Sensor MCX120A uses a 10-turn potentiometer as the sensing element for length measurement. It is designed for use as a feedback sensor in e.g. measuring the cutting depth of a planer. The Sensor consists of a 10-turn potentiometer, a spring mechanism and a spooled steel cable. The potentiometer with a total resistance of 1 kΩ (± 10 %) converts the cable length into a usable electrical signal. With the complete retracted cable the resistance between B and C is about 800 Ω. During pulling the cable the resistance is reduced down to minimum about 300 Ω. The calibration of the sensor is done in the connected control unit.