Datasheet4U Logo Datasheet4U.com

SC605 - Charge Pump Flash LED Driver

General Description

The SC605 is a high-current charge pump designed specifically for use with white LEDs used in camera flash applications.

Only two small bucket capacitors are required to develop the output drive, providing a low EMI solution compared to inductive boost regulators.

Key Features

  • Two selectable modes - Flash and Spotlight.
  • Up to 700mA output - Flash mode.
  • Up to 280mA output - Spotlight mode.
  • 500mA output over specified temperature and voltage ranges - Flash mode.
  • Spotlight mode selectable to 20%, 30% and 40% of Flash current.
  • 3.0V to 5.25V input range.
  • Flash control pin for synchronization to a camera module or graphics controller.
  • Short circuit, over-voltage and over-temperature protection.
  • Soft-start function.

📥 Download Datasheet

Datasheet Details

Part number SC605
Manufacturer SEMTECH
File Size 389.30 KB
Description Charge Pump Flash LED Driver
Datasheet download datasheet SC605 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
SC60220 Sine and cosine output high speed rotary encoder Semiment
SC60224 High Speed 12-Bit Magnetic Rotary Encoder Semiment
SC60228 High Speed 12-Bit Magnetic Rotary Encoder Semiment
SC6038 Linear Charge Management Controllers SUNCORE
SC6104 Triple-Output Power Supply SOUTHCHIP

Other Datasheets by SEMTECH

Part Number Description
SC600 mAhXLifeTM LED Driver with 5.0V a 4.5V or 4.0V Output
SC603 CHARGE PUMP REGULATOR WITH SELECTABLE 5.0V/4.5V OUTPUT
SC604A Low Noise - High Efficiency Regulated White LED Driver
SC606 Low Noise Smart LED Driver with Serial Interface
SC618 Charge Pump Flash LED Driver

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
POWER MANAGEMENT Description The SC605 is a high-current charge pump designed specifically for use with white LEDs used in camera flash applications. Only two small bucket capacitors are required to develop the output drive, providing a low EMI solution compared to inductive boost regulators. The SC605 has two modes of operation: Flash mode and Spotlight mode. In Flash mode, the SC605 is capable of delivering 500mA of regulated current for a duration of 500ms or up to 700mA for a reduced duration. In Spotlight mode the SC605 can output 20%, 30%, or 40% of the Flash mode current and remain enabled continuously. An external resistor is connected in series with the LED to set the current. In Flash mode, this resistor can dissipate up to 0.