Datasheet4U Logo Datasheet4U.com

SLX24C0816P - 8/16 Kbit 1024/2048 x 8 bit Serial CMOS EEPROMs/ I2C Synchronous 2-Wire Bus/ Page Protection Mode

Description

Serial Clock (SCL) The SCL input is used to clock data into the device on the rising edge and to clock data out of the device on the falling edge.

Features

  • Data EEPROM internally organized as 1024/2048 bytes and 64/128 pages × 16 bytes.
  • Page protection mode, flexible page-by-page hardware write protection.
  • Additional protection EEPROM of 64/128 bits, 1 bit per data page P-DIP-8-4.
  • Protection setting for each data page by writing its protection bit.
  • Protection management without switching WP pin.
  • Low power CMOS.
  • VCC = 2.7 to 5.5 V operation.
  • Two wire serial interface bus, I2C-B.

📥 Download Datasheet

Datasheet preview – SLX24C0816P
Other Datasheets by Siemens Semiconductor Group

Full PDF Text Transcription

Click to expand full text
Standard EEPROM ICs SLx 24C08/16/P 8/16 Kbit (1024/2048 × 8 bit) Serial CMOS-EEPROM with I2C Synchronous 2-Wire Bus and Page Protection Mode™ Data Sheet 1998-07-27 SLx 24C08/16/P Revision History: Previous Version: Page Page (in previous (in current Version) Version) 3 4, 5 5 5 11, 12 15 21 19 25 25 25 3 4, 5 – 5 11, 12 15 21 24 25 25 25 Current Version: 1998-07-27 06.97 Subjects (major changes since last revision) Text was changed to “Typical programming time 5 ms for up to 16 bytes”. CS0, CS1 and CS2 were replaced by n.c. The paragraph “Chip Select (CS0, CS1, CS2)” was removed completely. WP = VCC protects the upper half entire memory. The erase/write cycle is finished latest after 10 8 ms. Figure 11: second command byte is a CSR and not CSW.
Published: |