ST2601B Datasheet | Sitronix

FEATURES n Totally static 8-bit CPU n ROM: 128k x 8-bit n RAM: 1.5K x 8-bit n Stack: Up to 128-level deep n Operation voltage: 2.4V ~ 3.6V n Operation frequency: - 3.0Mhz@2.4V(Min.) - 4.0Mhz@2.7V(Min.) n LCD Drives - : 36 outputs. Eight shared with one output port - SEG: 56 outputs. Shared with 3 I/O ports and memory bus signals. n One 8x8 Signed Multiplier n Low Voltage Reset (LVR) - Two levels by code option n Low Voltage Detector (LVD) - Programmable 4 levels - System power or external battery level can be detected. n Programmable Watchdog Timer (WDT) n Memory interface to ROM, RAM, Flash n Memory configuration - Three kinds of banks for program, data and interrupt - 12-bit bank registers support up to 44M bytes - Six programmable chip-selects with 4 modes - Maximum single device of 16M bytes n General-Purpose I/O (GPIO) ports - Up to 39 bit programmable I/Os 8 dedicated CMOS I/Os 23 shared with LCD SEGs 8 open drain output pins shared with LCD s - Bit programmable pull-up for input pins - Pull-up/down and open-drain/CMOS control for Port-C n Timer/Counter - Four 12-bit timers. - One 8-bit base timer - Seven fixed base timers n Three clocking outputs - Clock sources including Timer0/1, baud rate generator n Eleven prioritized interrupts with dedicated exception vectors - External interrupt (edge triggered) - LCD buffer interrupt - Base timer interrupt - Timer0~3 interrupts (x4) - SPI interrupts (x2) - UART interrupts (x2) n Dual clock sources with warm-up timer - Low frequency crystal oscillator (OSCX)...32768 Hz - High frequency resistor or crystal/resonator oscillator (OSC) selected by pin option 455K~4M Hz n Direct Memory Access (DMA) - Block-to-Block transfer - Block to Single port n LCD Power Management - DC-DC converter with 8-level output control - LC driving voltage regulator with 16-level control - 1/4, 1/5, 1/6 bias options with 4 voltage followers n LCD Driver - 32x28~56x36 resolution, maximum 2016 dots - Clock source from...