Datasheet4U Logo Datasheet4U.com

AAT3103 - Three-Channel Charge-Pump LED Driver

General Description

The AAT3103 is a constant frequency charge-pump based current-source white LED driver capable of driving one to three LEDs up to 30mA, each.

The charge pumps automatically switch between 1x mode and 2x mode to maintain the highest efficiency and optimal LED current accuracy and matching.

Key Features

  • Source WLED Driver, up to 3 LEDs at up to 30mA, each.
  • Automatic Switching Between 1x and 2x Modes.
  • 900KHz Switching Frequency.
  • Linear LED Output Current Control.
  • Single-wire, S2Cwire Interface.
  • AAT3103-1: 16-step.
  • AAT3103-2: 8-step.
  • ON/OFF or PWM Interface.
  • AAT3103-4.
  • ±10% LED Output Current Accuracy.
  • ±3% LED Output Current Matching.
  • Low-current Shutdown Mode.
  • Built-in Short Circuit and Thermal Prot.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
AAT3103 3-Channel Charge-Pump LED Driver Advanced Analog Technology
AAT3104 Low Cost 1x/2x 4 Channel Charge Pump WLED Driver Advanced Analogic Technologies
AAT3110 MicroPower Regulated Charge Pump Advanced Analogic Technologies
AAT3110 MicroPower Regulated Charge Pump Skyworks Solutions
AAT3111 MicroPower Regulated Charge Pump Advanced Analogic Technologies

Other Datasheets by Skyworks Solutions

Part Number Description
AAT3104 Low Cost 1x/2x Four-Channel Charge Pump WLED Driver
AAT3105 Low Cost 1x/2x Four-Channel Charge Pump WLED Driver
AAT3112 500mA High Efficiency Charge Pump
AAT3119 High Efficiency 2X Charge Pump
AAT3120 Three-Channel Charge Pump

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
General Description The AAT3103 is a constant frequency charge-pump based current-source white LED driver capable of driving one to three LEDs up to 30mA, each. The charge pumps automatically switch between 1x mode and 2x mode to maintain the highest efficiency and optimal LED current accuracy and matching. A low external parts count (one 1μF flying capacitor, two small 1μF capacitors at IN and OUT and one current setting resistor) makes the AAT3103 ideally suited for small battery-powered applications. The AAT3103-1/-2 uses Skyworks' Simple Serial Control (S2Cwire™) interface to enable, disable, and program the LED driving current. The AAT3103-4 employs a Pulse Width Modulation (PWM) signal with up to 50kHz frequency, 10% to 100% duty cycle to program the LED current.