SG5010 Datasheet | TeGam

Features - Extremely low residual noise and distortion permit measurements on top-grade professional and consumer audio equipment. - Performs all standard audio tests - THD, IMD (SMPTE, DIN, CCIF difference tone), gain/loss, signalto-noise ratio. - Analyzer input fully balanced, oscillator output balanced or unbalanced, floating or grounded, 50/150/600 Ω to match all types of audio equlpment. - Automatic swept measurements possible without IEEE-488 controller. - Four-or-more digit synthesized frequency, 0.01% guaranteed accurate. - Fully programmable filter and detector selection to meet a wide variety of measurement standards. - High level oscillator output to test head room, clipping thresholds of line level devices. - Ten non-volatile stored generator setups. - Generator includes burst, square wave, and amplifier modes. SG 5010 / AA 5001 Programmable Audio Test System Automated Audio Test System Advantages TEGAM SG 5010 and AA 5001 programmable instruments in a puter controlled test system will make critical audio measurements consistently, accurately, and in two to four seconds each. Even plex tests can be made by non-technically-skilled operators since the procedures are controlled by software in the controller. And, permanent graphic or tabular records of test results can be produced at very low cost. An SG 5010/AA 5001 based system will automatically perform such industry standard tests as harmonic distortion to IHF A202, intermodulation distortion to SMPTE TH 22.51, DIN 45403, IEC 268.3, and IHF A202, frequency response to IHF A202, and noise or signal-to-noise ratio to IHF A202 (“A” weighting filter plies with ANSI specification S1.4 and IEC specification 179 for sound level meters). With the Option 02 capability of the AA 5001, noise measurements may be made to CCIR 468-2 and DIN 45405 standards. The SG 5010 also generates the burst signal necessary for dynamic headroom tests per IHF A202. A basic automated system consists of the SG 5010 Programmable...