TLSH156P Datasheet | Toshiba

TOSHIBA LED Lamp In Ga AℓP Red Light Emission Panel Circuit Indicator - - - - - - - - - - 5mm diameter(T1- 3 / 4) In Ga AℓP red LED All plastic mold type. Colorless clear lens Low drive current, high intensity red light emission Remended forward current: IF = 1~20m A(DC) All plastic molded lens, provides an excellent on- off contrast ratio. Fast response time, capable of pulse operation. High power luminous intensity Without stand- offs Applications: Suitable for outdoor message signboard, safety equipment, automotive use. Unit in mm Maximum Ratings (Ta = 25°C) Characteristic Forward current (DC) Reverse voltage Power dissipation Operating temperature range Storage temperature range Symbol IF VR PD Topr Tstg Rating 50 4 125 -30~85 -40~120 Unit JEDEC m A V m W °C °C ― ― EIAJ TOSHIBA Weight/: 0.31 g Electrical And Optical Characteristics (Ta = 25°C) Characteristic Forward voltage Reverse current Luminous intensity TLSH156P TLSH156P(RS) Symbol VF IR IV λP ∆λ λd IF = 20m A VR = 4V IF = 20m A IF = 20m A IF = 20m A IF = 20m A (Note) Test Condition Min - - 476 476 - - - Typ. 2.1 - 1400 - 623 15 613 Max 2.5 50 - 2300 - - - Unit V µA mcd nm nm nm Peak emission wavelength Spectral line half width Dominant Wavelength (Note): Lamps are classified into the following ranks according to their luminous intensity. Measurement tolerance for each limit is ±15%. R: 560-1120mcd, S: 1000-2000mcd, T: 1800-3600mcd. 2002-09-25 Precaution - - - Please be careful of the followings Soldering temperature: 260°C max Soldering time: 3s max (Soldering portion of lead: Up to 2mm from the body of the device) If the lead is formed, the lead should be formed up to 5mm from the body of the device without forming stress to the resin. Soldering should be performed after lead forming. This visible LED lamp also emits some IR light. If a photodetector is located near the LED lamp, please ensure that it will not be affected by this IR light. 2002-09-25...