TMP86C29B Datasheet | Toshiba

.. TMP86FM29 parison table of TMP86C829B/H29B/M29B/PM29A/PM29B/C929AXB and TMP86FM29 TMP86C829B TMP86CH29B TMP86CM29B ROM 8 K (Mask ROM) 16 K (Mask ROM) 32 K (Mask ROM) 512 1.5 K 1.5 K 42 pin 5 pin 10-bit AD converter × 8 ch 18-bit timer × 1 ch 8-bit timer × 4 ch 8-bit UART / SIO × 1 ch 32 seg × 4 4 ch 1.8 to 5.5 V at 4.2 MHz 2.7 to 5.5 V at 8 MHz 4.5 to 5.5 V at 16 MHz - 40 to 85℃ - N/A 1.8 to 5.25 V at 4.2 MHz 2.7 to 5.25 V at 8 MHz 4.5 to 5.25 V at 16 MHz 0 to 60°C TMP86PM29A TMP86PM29B TMP86C929AXB (Emulation chip) (Note 3) - TMP86FM29F Difference 32 K (OTP) 32 K (Flash) RAM I/O External Interrupt AD Converter Timer Counter Serial Interface LCD Key-on Wakeup Operating Voltage in MCU Mode Operating Temperature in MCU Mode Writing to Flash Memory CPU Wait (Note 1) 1.5 K - 42 pin (MCU part) 2K 42 pin 5 pin 10-bit AD converter × 8 ch 18-bit timer × 1 ch 8-bit timer × 4 ch 8-bit UART / SIO × 1 ch 32 seg × 4 (Note 2) 4 ch 1.8 to 3.6 V at 4.2 MHz (External clock) 1.8 to 3.6 V at 8 MHz (Resonator) 2.7 to 3.6 V at 16 MHz - 40 to 85°C 2.7 to 3.6V at 16 MHz 25°C ± 5°C Available Note 1: The CPU wait is a CPU halt function for stabilizing of power supply of Flash memory. The CPU wait period is as follows. In the CPU wait period except RESET, CPU is halted but peripheral functions are not halted. Therefore, if the interrupt occurs during the CPU wait period, the interrupt latch is set. In this case, if the IMF has been set to “1”, the interrupt service routine is executed after CPU wait period. For details refer to 2.14 “Flash Memory” in TMP86FM29 data sheet. Thus, even if the same software is executed in 86FM29 and 86C829B/H29B/M29B/PM29A/PM29B /C929AXB, the operation process is not the same. Therefore, when the final operating confirmation on target application is executed for software development of Mask ROM Product (86C829B/H29B/M29B), not the Flash product (86FM29) but the OTP product (86PM29A/PM29B) should be used. Condition After reset release Changing from...