Datasheet4U Logo Datasheet4U.com

TDA8547 - 2 x 0.7W BTL AUDIO AMPLIFIER

General Description

The UTC TDA8547 is a two channel audio power amplifier for an output power of 2 × 0.7W with a 16Ω load at a 5V supply.

At a low supply voltage of 3.3V an output power of 0.6W with an 8Ω load can be obtained.

Key Features

  • Selection between output channels.
  • Flexibility in use.
  • Few external components.
  • Low saturation voltage of output stage.
  • Gain can be fixed with external resistors.
  • Standby mode controlled by CMOS compatible levels.
  • Low standby current.
  • No switch-on/switch-off plops.
  • High supply voltage ripple rejection.
  • Protected against electrostatic discharge.
  • Outputs short-circuit safe to ground, VCC and across the load.
  • Thermally protected.
  • ORDERI.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
TDA8547 2 x 1 W BTL audio amplifier with output channel switching NXP
TDA8547TS 2 x 0.7 W BTL audio amplifier with output channel switching NXP
TDA8540 4 X 4 video switch matrix NXP
TDA8541 1 W BTL audio amplifier NXP
TDA8542 2 x 1 W BTL audio amplifier NXP

Other Datasheets by Unisonic Technologies

Part Number Description
TDA1519C STEREO POWER AMPLIFIER
TDA2003 10W CAR RADIO AUDIO AMPLIFIER
TDA2004 10+10W Stereo AMplifier
TDA2005 20W BRIDGE AMPLIFIER
TDA2009 10 +10W STEREO AMPLIFIER

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
UNISONIC TECHNOLOGIES CO., LTD TDA8547 LINEAR INTEGRATED CIRCUIT 2 × 0.7W BTL AUDIO AMPLIFIER WITH OUTPUT CHANNEL SWITCHING  DESCRIPTION The UTC TDA8547 is a two channel audio power amplifier for an output power of 2 × 0.7W with a 16Ω load at a 5V supply. At a low supply voltage of 3.3V an output power of 0.6W with an 8Ω load can be obtained. The circuit contains two BTL amplifiers with a complementary PNP-NPN output stage and standby/mute logic. The operating condition of all channels of the device (standby, mute or on) is externally controlled by the MODE pin. With the SELECT pin one of the output channels can be switched in the standby condition. This feature can be used for loudspeaker selection and also reduces the quiescent current consumption.