Datasheet4U Logo Datasheet4U.com

UC3875L - LOW COST POWER-SAVING MODE PWM CONTROLLER

General Description

The UTC UC3875L is a high performance current mode PWM controller ideally suited for low standby power.

The PWM switching frequency is programmable externally at normal operation.

Key Features

  • S.
  • UTC proprietary frequency hopping technology for Improved EMI performance.
  • Lower than 30mW Standby Power Design.
  • Dynamic peak current limiting for constant output power.
  • Built-in synchronized slope compensation.
  • OLP with automatic recovery.
  • OTP and OVP with latch up.
  • VDD clamp for higher security.
  • Programmable frequency.
  • Gate output voltage clamped at 16V.
  • Low start-up current.
  • Cycle-by-cycle Current Limiting.
  • Under voltage lockout.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
UC3875 Phase Shift Resonant Controller Unitrode
UC3871 Resonant Fluorescent Lamp Driver Unitrode
UC3872 Resonant Lamp Ballast Controller Unitrode
UC3874-1 Step-down (Buck) Controllers Unitrode
UC3874-2 Step-down (Buck) Controllers Unitrode

Other Datasheets by Unisonic Technologies

Part Number Description
UC3875 LOW COST POWER-SAVING MODE PWM CONTROLLER
UC3875A LOW COST POWER-SAVING MODE PWM CONTROLLER
UC3873 LOW COST POWER-SAVING MODE PWM CONTROLLER
UC3873B LOW COST POWER-SAVING MODE PWM CONTROLLER
UC3873C LOW COST POWER-SAVING MODE PWM CONTROLLER

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
UNISONIC TECHNOLOGIES CO., LTD UC3875L LOW COST POWER-SAVING MODE PWM CONTROLLER FOR FLYBACK CONVERTERS  DESCRIPTION The UTC UC3875L is a high performance current mode PWM controller ideally suited for low standby power. The PWM switching frequency is programmable externally at normal operation. Low VDD startup current make the power reliable on startup design and a large value resistor could be used in the startup circuit to minimize the standby power. At no load condition, the IC operates in power-saving mode for lower standby power, decreasing frequency for Higher conversion efficiency at light load condition.