TSOP93456DF1P Datasheet | Vishay

FEATURES - Improved dark sensitivity - Improved immunity against optical noise - Very low supply current - Photo detector and preamplifier in one package - Internal filter for PCM frequency - Supply voltage: 2.0 V to 3.6 V - Insensitive to supply voltage ripple and noise - Material categorization: for definitions of pliance please see .vishay./doc?99912 LINKS TO ADDITIONAL RESOURCES Product Page 3D 3D 3D Models Calculators Marking Holders Bends and Cuts DESCRIPTION The TSOP93...DF1P series devices are the latest generation miniaturized IR receiver modules for infrared remote control systems. These series provide improvements in sensitivity to remote control signals in dark ambient as well as in sensitivity in the presence of optical disturbances e.g. from CFLs. The devices contain a PIN diode and a preamplifier assembled on a lead frame. The epoxy package contains an IR filter. The demodulated output signal can be directly connected to a microprocessor for decoding. The TSOP932..DF1P and TSOP934..DF1P, series devices are designed to receive long burst codes (10 or more carrier cycles per burst). The third digit designates the AGC level (AGC2 or AGC4) and the last two digits designate the band-pass frequency (see table below). The higher the AGC, the better noise is suppressed, but the lower the code patibility. AGC2 provides basic noise suppression and AGC4 provides enhanced noise suppression. Generally, we advise to select the highest AGC that satisfactorily receives the desired remote code. These ponents have not been qualified to automotive specifications. MECHANICAL DATA 1 = OUT, 2 = GND, 3 = VS ORDERING CODE TSOP93...DF1P - 1100 pieces in tape and reel BLOCK DIAGRAM 16833-13 30 kΩ Input Band pass Demodulator Control circuit APPLICATION CIRCUIT 17170-12...