WD1003 - User Guide

Datasheet Summary

Description

NOTE DO NOT MOVE JUMPER W1 UNLESS YOUR OPERATING SYSTEM IS CONFIGURED TO ACCEPT TWO HARD DISK CONTROLLERS.

CERTAIN OPERATING SYSTEMS SUPPORT TWO CONTROLLERS IN THE SAME SYSTEM.

IBM DOS AND MANY IBMCOMPATIBLE OPERATING SYSTEMS DO NOT SUPPORT THIS FEATURE.

Western Digital

📥 Download Datasheet

Datasheet Details

Part number	WD1003
Manufacturer	Western Digital
File Size	54.35 KB
Description	User Guide
Datasheet	WD1003 Datasheet
Additional preview pages of the WD1003 datasheet.

📁 Similar Datasheet

WD100-110S12Q1 - DC-DC Converter (Aipu Electron)
WD100-110S24Q1 - DC-DC Converter (Aipu Electron)
WD100-24S12Q1 - DC-DC Converter (Aipu Electron)
WD100-24S24Q1 - DC-DC Converter (Aipu Electron)
WD100-48S12Q1 - DC-DC Converter (Aipu Electron)
WD100-48S24Q1 - DC-DC Converter (Aipu Electron)
WD1012EA-5 - 600mA Synchronous Step-Down Regulator (WillSEMI)
WD1015 - Step-down DC-DC Converter (WillSEMI)
WD1039EB - 1MHz Synchronous Step Down Regulator (WillSEMI)
WD150-110S12Q1 - DC-DC Converter (Aipu Electron)

Other Datasheets by Western Digital

WD1003-RA2 - Disk Controllers User Guide
WD1003-RAH - Disk Controllers User Guide
WD1003A-RA2 - Disk Controllers User Guide
WD1003S-RAH - Disk Controllers User Guide
WD1002 - User Guide
WD1002-05 - Winchester Floppy Disk Controller
WD1002-SHD - Winchester Controller OEM Manual
WD1004-27x - Winchester Disk Controller Boards

Full PDF Text Transcription

Click to expand full text

WD1002 WD1003 WD1002 WD1003 USER’S GUIDE 800-1910 (REV. 4-87) DOCUMENT SCOPE This document describes the hardware and software installation of the following boards: WD1002-WAH Winchester Disk Controller WDl002-WA2 Winchester/Floppy Disk Controller WDl003-WAH Winchester Disk Controller WDl003-WA2 Winchester/Floppy Disk Controller NOTE These controllers are designed for use in IBM Personal computer ATs or other AT-compatible computers with a 16bit data bus. The use of the term controller refers to all boards described within this document. When a specific reference is made to a particular board. the appropriate WD part number is used. 4. Attach 34-pin control connector pin 1 to J1 (J5 for WDl002-WA2 or WDl003-WA2) pin 1. Pin 1 is in the lower left hand corner of J1.

Published: Jun 15, 2005 |