W39V040A Datasheet | Winbond

.. W39V040A 512K × 8 CMOS FLASH MEMORY WITH LPC INTERFACE 1. GENERAL DESCRIPTION The W39V040A is a 4-megabit, 3.3-volt only CMOS flash memory organized as 512K × 8 bits. For flexible erase capability, the 4Mbits of data are divided into 8 uniform sectors of 64 Kbytes, which are posed of 16 smaller even pages with 4 Kbytes. The device can be programmed and erased in-system with a standard 3.3V power supply. A 12-volt VPP is not required. The unique cell architecture of the W39V040A results in fast program/erase operations with extremely low current consumption. This device can operate at two modes, Programmer bus interface mode and LPC bus interface mode. As in the Programmer interface mode, it acts like the traditional flash but with a multiplexed address inputs. But in the LPC interface mode, this device plies with the Intel LPC specification. The device can also be programmed and erased using standard EPROM programmers. 2. Features - Single 3.3-volt Operations: - 3.3-volt Read - 3.3-volt Erase - 3.3-volt Program - Hardware protection: - Optional 16K byte or 64K byte Top Boot Block with lockout protection - #TBL & #WP support the whole chip hardware protection - - - Fast Program Operation: - Byte-by-Byte programming: 35 µS (typ.) Flexible 4K-page size can be used as Parameter Blocks Low power consumption - Active current: 12.5 m A (typ. for LPC mode) Automatic program and erase timing with internal VPP generation End of program or erase detection - Toggle bit - Data polling - Fast Erase Operation: - Chip erase 100 m S (max.) - Sector erase 25 m S (max.) - Page erase 25 m S (max.) Fast Read access time: Tkq 11 n S Endurance: 10K cycles (typ.) Twenty-year data retention 8 Even sectors with 64K bytes each, which is posed of 16 flexible pages with 4K bytes Any individual sector or page can be erased - - - - - - - - - - Latched address and data TTL patible I/O Available packages: 32L PLCC, 32L...