WSH415 Datasheet Text
WSH415
Hall Effect IC with Two plementary Outputs
Features
:
- Operate from 2.8V to 28V supply voltage.
- On-chip Hall sensor.
- Internal bandgap regulator allows temperature pensated operations and a wide operating voltage range.
- High output sinking capability up to 600mA for driving large load.
- Lower current change rate reduces the peak output voltages during switching.
- Available in rugged low profile SIP-4L packages.
- Built-in protection diode for reverse power supply fault.
General Description: WSH415 is designed to integrate Hall sensor with two plementary output drivers on the same chip, it is suitable for speed measurement, revolution counting, positioning, and DC brushless motors. It includes a temperature pensated voltage regulator, a differential amplifier, a Hysteresis controller, two open-collector output drivers capable of sinking 600mA current load. An on-chip protection diode is implemented to prevent reverse power fault.
The temperature-dependent bias increases the supply voltage of the hall plates and adjusts the switching points to the decreasing induction of magnets at higher temperatures. Subsequently, the open collector output switches to the appropriate state.
WSH415 are rated for operation over temperature range from
- 20˚ C to 100˚C and voltage ranges from 2.8V to 28V.
Pin Descriptions: SIP-4L
Name Vcc OUT1 OUT2 Vss
P/I/O P O O P
Pin# Description
1
Positive Power Supply
2
Output Pin #1
3
Output Pin...