X25164 Datasheet | Xicor

DESCRIPTION 8K x 8 Bit 4K x 8 Bit 2K x 8 Bit FEATURES - Programmable Watchdog Timer with Reset Assertion - Reset Signal Valid to Vcc=1V - Power Up Reset Control - Save Critical Data With Block Lock TM Protection - Block Lock TM Protect 0, 1/4, 1/2 or all of Serial E2PROM Memory Array - In Circuit Programmable ROM Mode - Long Battery Life With Low Power Consumption - <50µA Max Standby Current, Watchdog On - <1µA Max Standby Current, Watchdog Off - <5m A Max Active Current during Write - <400µA Max Active Current during Read - 1.8V to 3.6V, 2.7V to 5.5V and 4.5V to 5.5V Power Supply Operation - 2MHz Clock Rate - Minimize Programming Time - 32 Byte Page Write Mode - Self-Timed Write Cycle - 5ms Write Cycle Time (Typical) - SPI Modes (0,0 & 1,1) - Built-in Inadvertent Write Protection - Power-Up/Power-Down Protection Circuitry - Write Enable Latch - Write Protect Pin - High Reliability - Available Packages - 14-Lead SOIC (X2564x) - 14-Lead TSSOP (X2532x, X2516x) - 8-Lead SOIC (X2532x, X2516x) BLOCK DIAGRAM SI SO SCK CS RESET/RESET DATA REGISTER MAND DECODE & CONTROL LOGIC RESET CONTROL These devices bine two popular functions, Watchdog Timer, and Serial E2PROM Memory in one package. This bination lowers system cost, reduces board space requirements, and increases reliability. The Watchdog Timer provides an independent protection mechanism for microcontrollers. During a system failure, the device will respond with a RESET/RESET signal after a selectable time-out interval. The user selects the interval from three preset values. Once selected, the interval does not change, even after cycling the power. The memory portion of the device is a CMOS Serial E2PROM array with Xicor’s Block Lock TM Protection. The array is internally organized as x 8. The device features a Serial Peripheral Interface (SPI) and software protocol allowing operation on a simple four-wire bus. The device utilizes Xicor’s proprietary Direct Write TM cell, providing a minimum endurance of 100,000 cycles per sector and a...