Datasheet4U Logo Datasheet4U.com

AS1151 - Quad LVDS Receivers

This page provides the datasheet information for the AS1151, a member of the AS1150 Quad LVDS Receivers family.

Description

The AS1150 and AS1151 are quad flow-through LVDS (low-voltage differential signaling) receivers which accept LVDS differential inputs and convert them to LVCMOS outputs.

The receivers are perfect for lowpower low-noise applications requiring high signaling rates and reduced EMI emissions.

Features

  • integrated parallel termination resistors (nominally 107Ω), which eliminate the requirement for discrete termination resistors, and reduce stub lengths. The integrated failsafe feature sets the output high if the inputs are open, undriven and terminated, or undriven and shorted. Enable inputs (EN and ENn.
  • internally pulled down to GND) control the high-impedance output and are common to all four receivers. All inputs conform to the ANSI TIA/EIA- 644 LVDS standards. Flow-through pinout s.

📥 Download Datasheet

Datasheet preview – AS1151

Datasheet Details

Part number AS1151
Manufacturer austriamicrosystems AG
File Size 191.75 KB
Description Quad LVDS Receivers
Datasheet download datasheet AS1151 Datasheet
Additional preview pages of the AS1151 datasheet.
Other Datasheets by austriamicrosystems AG

Full PDF Text Transcription

Click to expand full text
a u s t ri a m i c r o s y s t e m s www.DataSheet4U.com A S 11 5 0 , A S 11 5 1 Q u a d LV D S R e c e i v e r s D a ta S he e t 1 General Description The AS1150 and AS1151 are quad flow-through LVDS (low-voltage differential signaling) receivers which accept LVDS differential inputs and convert them to LVCMOS outputs. The receivers are perfect for lowpower low-noise applications requiring high signaling rates and reduced EMI emissions. The devices are guaranteed to receive data at speeds up to 500Mbps (250MHz) over controlled impedance media of approximately 100Ω. Supported transmission media are PCB traces, backplanes, and cables. The AS1150 uses high impedance inputs and requires an external termination resistor when used in a point-topoint connection.
Published: |