SN74ABT16833 Datasheet | Texas Instruments

description The ’ABT16833 consist of two noninverting 8-bit to 9-bit parity bus transceivers and are designed for munication between data buses. For each transceiver, when data is transmitted from the A bus to the B bus, an odd-parity bit is generated and output on the parity I/O pin (1PARITY or 2PARITY). When data is transmitted from the B bus to the A bus, 1PARITY (or 2PARITY) is configured as an input and bined with the B-input data to generate an active-low error flag if odd parity is not detected. SCBS097D - FEBRUARY 1991 - REVISED JANUARY 1997 SN54ABT16833 . . . WD PACKAGE SN74ABT16833 . . . DGG OR DL PACKAGE (TOP VIEW) 1OEB 1 1CLK 2 1ERR 3 GND 4 1A1 5 1A2 6 VCC 7 1A3 8 1A4 9 1A5 10 GND 11 1A6 12 1A7 13 1A8 14 2A1 15 2A2 16 2A3 17 GND 18 2A4 19 2A5 20 2A6 21 VCC 22 2A7 23 2A8 24 GND 25 2ERR 26 2CLK 27 2OEB 28 56 1OEA 55 1CLR 54 1PARITY 53 GND 52 1B1 51 1B2 50 VCC 49 1B3 48 1B4 47 1B5 46 GND 45 1B6 44 1B7 43 1B8 42 2B1 41 2B2 40 2B3 39 GND 38 2B4 37 2B5 36 2B6 35 VCC 34 2B7 33 2B8 32 GND 31 2PARITY 30 2CLR 29 2OEA The error (1ERR or 2ERR) output is configured as an open-collector output. The B-to-A parity-error flag is clocked into 1ERR (or 2ERR) on the low-to-high transition of the clock (1CLK or 2CLK) input. 1ERR (or 2ERR) is cleared (set high) by taking the clear (1CLR or 2CLR) input low. The output-enable (OEA and OEB) inputs can be used to disable the device so that the buses are effectively isolated. When both OEA and OEB are low, data is transferred from the A bus to the B bus and inverted parity is generated. Inverted parity is a forced error condition that gives the designer more system diagnostic capability. To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver. Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas...